Thermoporoelastoplastic Wellbore Breakout Modeling by Finite Element Method

نویسندگان

چکیده

Drilling a hole into rock results in stress concentration and redistribution close to the hole. When induced stresses exceed strength, wellbore breakouts will happen. Research on breakout is fundamental of stability. A sequence concentrations, falling, redistributions, which involve initiation, propagation, stabilization sequences. Therefore, simulating process very challenging. Thermoporoelastoplastic models for analysis are rare due high complexity problem. In this paper, fully coupled thermoporoelastoplastic finite element model built study mechanism breakouts. The breakouts, influence temperature comparison between thermoporoelastic studied paper. For modeling, D-P criterion used determine whether starts yield or not, maximum tensile strain have happened.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A Proposed Modeling Method in Finite Element Slope Stability Analysis

Limit-equilibrium method (LEM) and finite element method (FEM) with strength reduction method (SRM) techniques are the most widely used analysis tools in slope stability assessment. Recently, researchers have reported that both factor of safety (FOS) values and failure surfaces obtained from LEM and FEM are generally in good agreement, except in some particular cases. In this paper, the FOS and...

متن کامل

Evaluation of Fracture Parameters by Coupling the Edge-Based Smoothed Finite Element Method and the Scaled Boundary Finite Element Method

This paper presents a technique to evaluate the fracture parameters by combining the edge based smoothed finite element method (ESFEM) and the scaled boundary finite element method (SBFEM). A semi-analytical solution is sought in the region close to the vicinity of the crack tip using the SBFEM, whilst, the ESFEM is used for the rest of the domain. As both methods satisfy the partition of unity...

متن کامل

Solution of Wave Equations Near Seawalls by Finite Element Method

A 2D finite element model for the solution of wave equations is developed. The fluid is considered as incompressible and irrotational. This is a difficult mathematical problem to solve numerically as well as analytically because the condition of the dynamic boundary (Bernoulli’s equation) on the free surface is not fixed and varies with time. The finite element technique is applied to solve non...

متن کامل

بررسی جواب های کامپکتون معادلات دیفرانسیل غیرخطی با استفاده از finite element method

کامپکتون ها، سالیتون هایی با پهنای محدود هستند. معادلات(k(m,n به ازای مقادیر خاصی از m و n دارای جواب کامپکتون هستند. از جمله این معادلات، معادلات (k(2,2 و (k(3,3 است. به دلیل خاصیت شبه ذره ای کامپکتون ها، این امواج بسیار مورد توجه فیزیکدانان قرار گرفته اند. برای بررسی کامپکتون ها، روش های عددی بسیاری وجود دارد. یکی از این روش ها که می توان برای حل این معادلات از آن استفاده کرد، روش المان های م...

15 صفحه اول

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Mining

سال: 2022

ISSN: ['2673-6489']

DOI: https://doi.org/10.3390/mining2010004