Thermoplastic Overmolding onto Injection-Molded and In Situ Polymerization-Based Polyamides
نویسندگان
چکیده
منابع مشابه
Fiber Orientation in Injection Molded Long Carbon Fiber Thermoplastic Composites
A set of edge-gated and center-gated plaques were injection molded with long carbon fiber-reinforced thermoplastic composites, and the fiber orientation was measured at different locations of the plaques. Autodesk Simulation Moldflow Insight (ASMI) software was used to simulate the injection molding of these plaques and to predict the fiber orientation, using the Anisotropic Rotary Diffusion an...
متن کاملWear resistance of injection-molded thermoplastic denture base resins
Objective This study investigated the wear resistance of injection-molded thermoplastic denture base resins using nanoindentation instrument. Materials and methods Six injection-molded thermoplastic denture base resins (two polyamides, two polyesters, one polycarbonate, one polymethylmethacrylate [PMMA]) and a PMMA conventional heat-polymerized denture-based polymer control were tested. Elastic...
متن کاملIN SITU SILICA SUPPORTED METALLOCENE CATALYSTS FOR ETHYLENE POLYMERIZATION
Bis(2-R-ind)ZrCl2 (R: H or phenyl) was supported on different types of silica by in situ impregnation method and used for ethylene polymerization. In this method, the step of catalyst loading on support was eliminated and common alkyl aluminum (triisobutylaluminum, TiBA) cocatalyst was used instead of expensive methyl aluminiumoxane (MAO) cocatalyst in the polymerization. The effect of surface ...
متن کاملInjection Molded Millimeter-Wave Horn Array Antenna
This paper shows injection molded millimeter-wave horn array antenna for the 1-dimensional APAA(Active Phase Array Antenna). The antenna is composed of horn antennas, grooved circular waveguide polarizers, E-plane T-junctions, and E-plane bends employing dielectric waveguides. This structure makes it possible to manufacture a feed circuit and radiating elements as an integrated unit by using in...
متن کاملThermal Processing of Injection-Molded Silicon Carbide
Silicon carbide is the most important and versatile non-oxide ceramic. Powder injection molding (PIM) is a method of high-speed fabrication of complex near-net shapes of SiC and other powders. Green micro-machining (GMM) is used to extend the shaping capability of green ceramics and powder metallurgy to smaller feature sizes. Debinding—removal of organic additives—is the rate-limiting step in P...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2018
ISSN: 1996-1944
DOI: 10.3390/ma11112140