Thermomechanical Analysis of an Electrically Assisted Wire Drawing Process
نویسندگان
چکیده
منابع مشابه
Lawd – Laser Assisted Wire Drawing
In conventional wire drawing the diameter of a wire or rod-like workpiece is reduced by drawing it through a conical die. Dieless drawing of a wire or a rod is realized by a localized heating of the work piece. As heat source for example an induction coil can be used. Immediately after having passed the heating zone the work piece is cooled to restrict the heat input on very small region. By ap...
متن کاملAdvances in wire drawing process by theoretical and numerical analysis
Ductile metal deformation processes aimed at production of wire of some sort are in use since over five thousand years, early ones dating back to the origins of copper and gold produc tion. Thin sheets, initially produced by hammering, were cut into thin strips suitable for ornamental pur poses. The introduction of die plate paved the way to round wire manufac turing, rather severe limitatio...
متن کاملInfluence of an Inclusion on Multi-Pass Copper Shaped-Wire Drawing by 2D Finite Element Analysis
The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملan infinite planar array of rectangular microstrip patch antenna analysis
the methods which are used to analyze microstrip antennas, are divited into three categories: empirical methods, semi-empirical methods and full-wave analysis. empirical and semi-empirical methods are generally based on some fundamental simplifying assumptions about quality of surface current distribution and substrate thickness. thses simplificatioms cause low accuracy in field evaluation. ful...
15 صفحه اولذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Manufacturing Science and Engineering
سال: 2017
ISSN: 1087-1357,1528-8935
DOI: 10.1115/1.4037798