Thermodynamics of Nitrogen in Fe-Mn-Al-Si-C Alloy Melts

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Transformation Reversibility in Fe-Mn-Si Shape Memory Alloy

The change of the surface relief associated with stress-induced epsilon martensite before and after the reverse transformation in an Fe-33%Mn-6%Si alloy (Msz264K) has been investigated. The permanent strain of a 2.7% tensile-strained specimen was 1.1% after the reverse transformation. In this specimen, a large part of surface relief still remained after heating to 623K (above Af). When five tra...

متن کامل

The Determination of the Activities in Mn-C and Mn-Si Melts

The activities of manganese in Mn-C and Mn-Si melts at 1673K have been determined. The transportation method was applied to the vapor pressure measurement. The activities of manganese in the Mn-C melts as referred to pure liquid manganese showed the positive deviation from ideality at less than 0.17 atomic fraction of carbon and deviated negatively above this value. The activities of manganese ...

متن کامل

Modification of Primary Si Crystals and Fe-rich Intermetallics in LM28 Al Alloy Fabricated Through Thixoforming

In the present research, thixoforming route was carried out in order to enhance the microstructural features of LM28 piston alloy. Typical microstructure of this alloy was composed of coarse, polygonal primary silicon particles, eutectic matrix and intermetallic phases. Thermal analysis was carried out to study the solidification path of the base alloy and determine the major arrest temperature...

متن کامل

Effect of heterogeneously distributed pre-existing dispersoids on the recrystallization behavior of a cold-rolled Al-Mn-Fe-Si alloy

a r t i c l e i n f o It is well known that strong concurrent precipitation, mainly located along grain/subgrain boundaries, results in a coarse and elongated grain structure, and unusual sharp P {011} b566N and/or M {113} b110N texture components during annealing of supersaturated AA3xxx-series alloys. In this study, a supersaturated as-cast Al–Mn– Fe–Si alloy was annealed at three temperature...

متن کامل

Microstructural evolution during isothermal annealing of a cold-rolled Al-Mn-Fe-Si alloy with different microchemistry states

In this paper, investigation of the softening behaviour of a supersaturated Al-Mn-Fe-Si alloy during annealing after cold rolling has been carried out. Two different homogenization conditions were considered, of which one gives a condition of a large amount of small pre-existing dispersoids, i.e. providing a significant static Zener drag, while the other gives a condition where both concurrent ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Metallurgical and Materials Transactions B

سال: 2016

ISSN: 1073-5615,1543-1916

DOI: 10.1007/s11663-016-0588-y