Thermodynamic Analysis of the Sn-Ag-Bi Ternary Phase Diagram
نویسندگان
چکیده
منابع مشابه
The 1300 8 C isothermal section in the Nb – Sn – C ternary phase diagram
In this paper we map out the 1300 8C isothermal section in the Nb–Sn–C ternary system. The results show that the only ternary compound in the system, Nb SnC, is in equilibrium with Sn, NbC , and Nb Sn, but not with Nb, Nb C or C. The Nb SnC phase is not a 2 x 3 2 2 stoichiometric compound but exists over a range of compositions that range from an Nb:Sn:C ratio of |54:22:24 at.%, when in equilib...
متن کاملThermodynamic modelling of the Ag-Cu-Ti ternary system
Ag-Cu-Ti system is important for brazing applications and mainly for ceramic joining. This system is characterized by numerous intermetallics in the Cu-Ti binary and the existence of a miscibility gap in the liquid phase. For applications, the knowledge of phase equilibria, invariant reactions in the temperature range of interest and thermodynamic activity values (mainly of Ti) are important. T...
متن کاملCreep Behavior of a Sn-Ag-Bi Pb-Free Solder
Compression creep tests were performed on the ternary 91.84Sn-3.33Ag-4.83Bi (wt.%, abbreviated Sn-Ag-Bi) Pb-free alloy. The test temperatures were: −25 °C, 25 °C, 75 °C, 125 °C, and 160 °C (± 0.5 °C). Four loads were used at the two lowest temperatures and five at the higher temperatures. The specimens were tested in the as-fabricated condition or after having been subjected to one of two air a...
متن کاملTernary Phase Diagram Modeling of Chiral Medetomidine Salts Using NRTL-SAC Model
Experimental determination of solubility and ternary phase diagram of chiral compound are of tedious and time consuming tasks, and in many cases, there is not enough experimental data for different enantiomeric compositions to access the experimental ternary phase diagram. Using thermodynamic models with predictive capability, having less dependency on experimental data, affords a great advanta...
متن کاملThe Kinetics of Formation of Ternary Intermetallic Alloys in Pb-Sn and Cu-Ag-Sn Pb-free Electronic Joints
A simple model of the formation of Au0.1Ni0.1Sn0.8 in Pb-Sn solder/Ni interconnects is examined by numerical simulation. Previous experimental observation has shown that after reflow the interface consists of the Ni3Sn4 alloy between Pb-Sn solder and Ni, with Au distributed through the PbSn solder ball. Au0.1Ni0.1Sn0.8 was observed to form at the Pb-Sn solder/Ni3Sn4 interface during annealing a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2001
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.42.722