THERMAL STRESS ANALYSIS OF INTEGRATED COMBUSTION ENGINE PISTON USING CAE TOOLS (ALUMINUM SILICON ALLOY, ALUMINUM SILICON ALLOY STEEL)

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Evaluation of continuum damage at different temperatures for aluminum-silicon alloy of engine piston within low-cycle fatigue regime

In this article, the isothermal low-cycle fatigue continuum damage in the engine piston aluminum alloy has been evaluated at different temperatures. For this objective, experimental data of low-cycle fatigue tests on standard specimens were used at 280, 350 and 425°C. Based on the continuum damage mechanics method, the fatigue damage was calculated during cyclic loading. Obtained results, inclu...

متن کامل

Dynamic and Thermal Properties of Aluminum Alloy A356/Silicon Carbide Hollow Particle Syntactic Foams

Aluminum alloy A356 matrix syntactic foams filled with SiC hollow particles (SiCHP) are studied in the present work. Two compositions of syntactic foams are studied for quasi-static and high strain rate compression. In addition, dynamic mechanical analysis is conducted to study the temperature dependent energy dissipation and damping capabilities of these materials. The thermal characterization...

متن کامل

Mechanical properties of wood-derived silicon carbide aluminum-alloy composites as a function of temperature

J. Llorca Departamento de Ciencia de Materiales, Universidad Politécnica de Madrid, E. T. S. de Ingenieros de Caminos, 28040 Madrid, Spain; and Instituto Madrileño de Estudios Avanzados en Materiales (IMDEA-Materiales) E. T. S. de Ingenieros de Caminos, 28040 Madrid, Spain K.T. Faber Department of Materials Science and Engineering, Robert R. McCormick School of Engineering and Applied Science, ...

متن کامل

Aluminum–Titanium Alloy Back Contact Reducing Production Cost of Silicon Thin-Film Solar Cells

In this study, metal films are fabricated by using an in-line reactive direct current magnetron sputtering system. The aluminum–titanium (AlTi) back contacts are prepared by changing the pressure from 10 mTorr to 25 mTorr. The optical, electrical and structural properties of the metal back contacts are investigated. The solar cells with the AlTi had lower contact resistance than those with the ...

متن کامل

Evaluating the coupled thermo-mechanical stresses for an aluminum alloy piston used in a gasoline engine XU7

In modern engines with higher compression ratios, severe pressures and non-uniform heating up is occurred for the engine parts. The piston as the most critical part among all automotive components has been the subject of numerous studies on calculation of temperature distribution, but thermal stress analyses are limited. In this study, the piston of gasoline engine XU7 which is widespread in Ir...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Acta Mechanica Malaysia

سال: 2020

ISSN: 2616-4302

DOI: 10.26480/amm.01.2020.20.23