Thermal Stress Analysis in ZrO2 Insulation Coatings on Cr-Ni Substrates during Cooling Process
نویسندگان
چکیده
منابع مشابه
Analyzing and Modelling the Corrosion Behavior of Ni/Al2O3, Ni/SiC, Ni/ZrO2 and Ni/Graphene Nanocomposite Coatings
A study has been presented on the effects of intrinsic mechanical parameters, such as surface stress, surface elastic modulus, surface porosity, permeability and grain size on the corrosion failure of nanocomposite coatings. A set of mechano-electrochemical equations was developed by combining the popular Butler-Volmer and Duhem expressions to analyze the direct influence of mechanical paramete...
متن کاملMagnetocaloric Properties of Fe-Ni-Cr Nanoparticles for Active Cooling
Low cost, earth abundant, rare earth free magnetocaloric nanoparticles have attracted an enormous amount of attention for green, energy efficient, active near room temperature thermal management. Hence, we investigated the magnetocaloric properties of transition metal based (Fe70Ni30)100-xCrx (x = 1, 3, 5, 6 and 7) nanoparticles. The influence of Cr additions on the Curie temperature (TC) was s...
متن کاملThermal Conductivity, Phase Stability, and Oxidation Resistance of Y3Al5O12 (YAG)/Y2O3–ZrO2 (YSZ) Thermal-Barrier Coatings
This paper describes a new multilayer TBC that incorporates a 10 μm-thick oxygen barrier layer of yttrium–aluminum garnet (YAG) into a typical YSZ TBC system. The thermal conductivity of as-sprayed YAG/YSZ coatings was reduced due to excessive porosity and amorphous areas in the YAG layer. After long-term heat treatments, the conductivity of the multilayer was unaffected by the presence of YAG....
متن کاملCryogenic Nitrogen Gas Cooling for Thermal Spray Coatings
Current Process HVOF thermal spray is widely used for coating critical wear parts like landing gear, bearing races, valves and turbine components. Generally, fully or partially molten metal, composite, or ceramic droplets are propelled from a gun or torch onto the workpiece. Multiple passes are required to build up the coating, since each pass only deposits ~ 0.0002 in 0.0005 in thickness of ma...
متن کاملPVD coatings on aluminium substrates
It is well known that aluminium is today the most widely used metallic material besides steel. The mechanical characteristics of aluminium offer an increasing application field, especially where lightweight constructions are required. The demands for improved characteristics such as higher strength and greater durability are achieved by the development of new aluminium alloys. Continuous effort...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mathematical and Computational Applications
سال: 2011
ISSN: 2297-8747
DOI: 10.3390/mca16030598