Thermal Spraying Techniques. Current Technologies in High Velocity Combustion Flame Spraying Process.
نویسندگان
چکیده
منابع مشابه
Breaks in Thermal Spraying Processes
The detection of structural changes in time series from industrial processes monitoring is of great interest. We investigate the limits and possibilities of two recently developed methods, one for the off-line detection of changed volatilities [Wied et al., 2011] and one for the on-line detection of changes in the course of the time series [Borowski and Fried, 2011]. The investigation is carrie...
متن کاملSplat Formation Mechanism in Thermal Spraying*
In order to understand the splat formation process of individual splat deposited by thermal spraying, commercially available Nickel powders with diameter of several tens micrometers were thermally sprayed onto mirror polished AISI304 substrate surface. The deposited splat shows transition phenomenon from splash type to disk one in flattening on collision onto substrate surface according to both...
متن کاملWarm spraying-a novel coating process based on high-velocity impact of solid particles.
In recent years, coating processes based on the impact of high-velocity solid particles such as cold spraying and aerosol deposition have been developed and attracting much industrial attention. A novel coating process called 'warm spraying' has been developed, in which coatings are formed by the high-velocity impact of solid powder particles heated to appropriate temperatures below the melting...
متن کاملInvestigation of Substrate Microstructure after Flame Spraying and Fusing
Original scientific paper In this paper, influence of flame spraying and fusing on microstructure of substrates made from heat treated carbon steel C45, a heat treated low alloyed 42CrMo4 steel and stainless austenitic steel X6CrNiMo18-10-2, has been investigated. Flame spraying and fusing is a deposition technique commonly applied to nickel-base self-fluxing alloys (NiCrBSi alloys). Because of...
متن کاملUltrafine particles emitted by flame and electric arc guns for thermal spraying of metals.
The ultrafine aerosol emitted by thermal spraying of metals using flame and electric arc processes has been characterized in terms of particle size distribution and emission rates based on both particle number and mass. Thermal spraying of Zn, Zn/Al, and Al was studied. Measurements taken using an electrical low pressure impactor and a condensation nucleus counter reveal an aerosol made up of v...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Surface Finishing Society of Japan
سال: 1998
ISSN: 0915-1869,1884-3409
DOI: 10.4139/sfj.49.572