Thermal Properties and Structures of Ni-Cr Alloy Sparayed Coating.

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Mechanical and Electrochemical Properties of DC-Electrodeposited Ni-Mn Alloy Coating with Low Internal Stress

The nickel-manganese (Ni-Mn) alloy coating prepared from DC electrodeposition process in sulphamate bath was studied. The effects of process parameters, such as current density and electrolyte composition, on the cathodic current efficiency, microstructure, internal stress and mechanical properties were investigated. Because of its crucial effect on the application to the electroforming of micr...

متن کامل

The effect of recasting on biological properties of Ni-Cr dental alloy

Aleksandra ČAIROVIĆ Faculty of Dental Medicine University of Belgrade Clinic for Prosthodontics Rankeova 4, 11000 Belgrade Serbia [email protected] SUMMARY Introduction Increases in market prices of gold over the last 20 years have led to expansion of basic dental alloys, which, primarily due to their good mechanical properties and acceptable prices, have found their place in everyday...

متن کامل

Ni-B Coating Production on Magnesium Alloy by Electroless Deposition

The use of magnesium alloys is limited due to their susceptibility to corrosion although they have many attractive physical and mechanical properties. To increase mechanical and corrosion properties of these alloys, many deposition method and coating types are used. Electroless Ni–B coatings have received considerable interest recently due to its unique properties such as cost-effectiveness, th...

متن کامل

Formation and Properties of Ni-Based Amorphous Metallic Coating Produced by HVAF Thermal Spraying

A highly dense Ni59Zr20Ti16Si2Sn3 partial amorphous metallic coating, about 500mm thick, was fabricated by means of HVAF (High Velocity Air Fuel) thermal spraying. Amorphous alloy powders produced by using gas atomization were used for HVAF thermal spraying to produce an amorphous metallic coating. Microstructural investigation showed that crystallization and oxidation occurred during thermal s...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of the Surface Finishing Society of Japan

سال: 1996

ISSN: 0915-1869,1884-3409

DOI: 10.4139/sfj.47.550