Thermal hydraulics in FBR cover gas related to component development.
نویسندگان
چکیده
منابع مشابه
Thermal Hydraulics Design Limits
The following discussion of PWR steady state and transient design limits is extracted from the theses of Carter Shuffler and Jarrod Trant while the BWR discussion is extracted from Paolo Ferroni's thesis (covers steady state only). These limits are a simplified and narrower discussion than the relevant NRC standard review plan you will also be referred to. All materials are directly extracted f...
متن کاملAppendix 1 Thermal Hydraulics, Draft for Comment
Several different fuel failure criteria have been used in previously NRC-sponsored SFP accident studies. Benjamin, et. al. used the onset of runaway fuel clad oxidation as the fuel failure criterion in NUREG/CR-0649 [Ref. 1]. This criterion was criticized because clad rupture can occur at a relatively low temperature causing a gap release. The consequences of gap release can be significant if t...
متن کاملImportance Analysis for Uncertain Thermal-Hydraulics Transient Computations
Results of the codes simulating transients and abnormal conditions in nuclear power plants are inevitably uncertain. In application to thermal-hydraulic calculations by thermal-hydraulics codes, uncertainty importance analysis can be used to quantitatively confirm the results of qualitative phenomena identification and ranking table (PIRT). Several methodologies have been developed to address u...
متن کاملDevelopment of High Performance Clarification System for FBR Dissolver Liquor
A high performance clarification system has been discussed for advanced aqueous reprocessing of FBR spent fuel. Dissolver residue gives the cause of troubles on the plant operation of reprocessing. In this study, the new clarification system based on the hybrid of centrifuge and filtration was proposed to get the high separation ability of the component of whole insoluble sludge. The clarificat...
متن کاملThermal Hydraulics of Accelerator-Driven System Windowless Targets
The study of the fluid dynamics of the windowless spallation target of an accelerator-driven system (ADS) is presented. Several target mockup configurations have been investigated: the first one was a symmetrical target, which was made by two concentric cylinders and the other configurations are not symmetrical. In the experiments, water has been used as hydraulic equivalent to lead–bismuth eut...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Atomic Energy Society of Japan / Atomic Energy Society of Japan
سال: 1988
ISSN: 0004-7120
DOI: 10.3327/jaesj.30.1084