Thermal-Hydraulic Characteristics of Carbon Dioxide in Printed Circuit Heat Exchangers with Staggered Airfoil Fins

Heat Transfer and Pressure Drop Characteristics in Straight Microchannel of Printed Circuit Heat Exchangers

Performance tests were carried out for a microchannel printed circuit heat exchanger (PCHE), which was fabricated with micro photo-etching and diffusion bonding technologies. The microchannel PCHE was tested for Reynolds numbers in the range of 100‒850 varying the hot-side inlet temperature between 40 °C–50 °C while keeping the cold-side temperature fixed at 20 °C. It was found that the average...

Thermal-Hydraulic Performance of Metal Foam Heat Exchangers

Due to their large surface-area-to-volume ratio and tortuous structure, metal foams hold promise for heat transfer applications. Both of these factors increase the heat transfer by enhancing the mixing and surface area. The main disadvantage associated with their thermal-hydraulic performance is relatively higher pressure drop, resulting in larger pumping power requirements if they are used in ...

Analysis of Supercritical Carbon Dioxide Heat Exchangers in Cooling Process

Numerical Analysis of Printed Circuit Board with Thermal Vias: Heat Transfer Characteristics under Nonisothermal Boundary Conditions

A thermal via has been used to enhance the heat transfer through the printed circuit board (PCB). Because the thermal conductivity of a dielectric material is very low, the array of metal vias is placed to make thermal paths in the PCB. This paper describes the numerical analysis of the PCB having metal vias and focuses on the heat transfer characteristics under the nonisothermal boundary condi...

Improvement of Energy Efficiency using Porous Fins in Heat Exchangers

The forced convection heat transfer in high porosity metal-foam filled tube heat exchangers are studied in this paper. The Brinkman Darcy momentum model and two energy equations for both solid and fluid phases in porous media are employed .The study shows that using metal-foams can significantly improve the heat transfer in heat exchangers. Keywords—metal foam, Nusselt number, heat exchanger, h...