Thermal deformation analysis of Spliced high energy laser emission window
نویسندگان
چکیده
منابع مشابه
Numerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملThermal Analysis of Laser Hardening for Different Moving Patterns
Transient thermal field in laser surface hardening treatment of medium carbon steel was analyzed by employing both three-dimensional analytical model and finite element model. In finite element model the laser beam was considered as a moving plane heat flux to establish the temperature rise distribution in the work-piece, while in analytical model laser beam was considered as an internal heat s...
متن کاملHigh-Energy Non-Thermal and Thermal Emission from GRB141207A detected by Fermi
The bright long gamma-ray burst GRB 141207Awas observed by the Fermi Gamma-ray Space Telescope and detected by both instruments onboard. The observations show that the spectrum in the prompt phase is not well described by the canonical empirical Band function alone, and that an additional power-law component is needed. In the early phase of the prompt emission, a modified blackbody with a hard ...
متن کاملHigh temperature thermal energy
..................................................................................................................................................II CONTENT...................................................................................................................................................III FIGURES......................................................................................
متن کاملThermo-mechanical analysis on thermal deformation of thin stainless steel in laser micro-welding
In the present study, a three-dimensional finite element model has been developed to simulate the temperature, stress and deformation fields in continuous wave (CW) laser micro-welding of thin stainless steel sheet. The welding deformation was experimentally evaluated using a single-mode fiber laser with a high-speed scanning system. Application of developed thermal model demonstrated that the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2017
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/244/1/012018