Thermal cycling damage monitoring of thermal barrier coating assisted with LASAT (LAser Shock Adhesion Test)
نویسندگان
چکیده
منابع مشابه
Evaluation of thermal conduction anisotropy on Thermal Barrier Coating
The microstructural analysis of Thermal Barrier Coatings, deposited according to the Air Plasma Spray technology, furnishes information according which a strong orthotropic thermal conductivity is expected to be measured for such a material. Pulsed experiment with a localized heating source and thermographic temperature recording, permit to evaluate both the in-depth and in-plane components of ...
متن کاملThermal Conductivity of a Zirconia Thermal Barrier Coating
The conductivity of a thermal-barrier coating composed of atmospheric plasma sprayed 8 mass percent yttria partially stabilized zirconia has been measured. This coating was sprayed on a substrate of 410 stainless steel. An absolute, steady-state measurement method was used to measure thermal conductivity from 400 to 800 K. The thermal conductivity of the coating is 0.62 W/(m⋅K). This measuremen...
متن کاملCrack propagation in thermal barrier coating systems
Thermal barrier coating systems are used on top of highly stressed components in gas turbines to protect the nickel-based substrates. A well-established thermal barrier coating system consist of the bond-coat (BC) and the thermal barrier coating (TBC). A third layer is grown during service: the thermally grown oxide (TGO) between the BC and the TBC. The coatings fail in service because of diffe...
متن کاملTHERMAL SHOCK OF REFRACTORIES
Being brittle and having low thermal conductivity, refractories suffer damage and sometimes fail in service as a result of thermal shock. While the approach of those making fine-grained technical ceramics is to make their products sufficiently strong to withstand thermal stresses the refractory technologist is more cunning. He uses, often little known, devices to provide resistance to thermal s...
متن کاملThermal Impedance Monitoring during Power Cycling Tests
In this publication a new method of thermal impedance analysis of power modules is presented. It enables a distinction of different failure mechanisms within the heat flow path by electrical measurement during power cycling tests. With measurement and evaluation of the thermal impedance Zth the degradation can be located within chip solder layer, system solder layer and thermal interface materi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Surface and Coatings Technology
سال: 2019
ISSN: 0257-8972
DOI: 10.1016/j.surfcoat.2019.125048