Thermal and magnetic measurements on YBa2Cu3O7−y

AC Magnetic Measurements on Superconductors: Design of a Device for Magneto-Thermal Measurements

This work describes the design and realisation of an apparatus to measure simultaneously the AC magnetic properties and the temperature distribution on the top surface of bulk superconducting samples (up to 32 mm in diameter) in cryogenic conditions (temperature range 78-120 K). First the authors describe the experimental set-up used for simultaneous thermal and magnetic characterization of the...

Magnetic and Magnetoelectric Measurements on Ba2CoGe2O7

Thermal synthesis of Hematite nanoparticles: Structural, magnetic and morphological characterizations

Hematite (α-Fe2O3) nanoparticle was synthesized using organometallic compound - ferrocene carboxaldehyde through solventless solid state thermal decomposition technique. The crystal structure, magnetic and morphological properties of the decomposed material were studied using powder X-ray diffraction (XRD), superconducting quantum interference device (SQUID) magnetometry, ...

Thermal and Magnetic Characteristics of Cellulose Acetate- Fe3O4

Fe3O4 nanoparticles were synthesizedviaa simple chemical reaction between FeCl2.4H2O and Fe(NO3)3.9H2O under nitrogen atmosphere at room temperature, and then nanoparticles were added to cellulose acetate (CA) polymer. The influence of nanoparticles on the thermal properties of CA polymeric matrix was studied using the...

Measurements and Modeling of Flue Height Influence on Air Pollution Emissions and Thermal Efficiency of Natural Draught Gas Fired Boilers

This paper presents and analyses results from experimental and CFD work undertaken on a 24 kW domestic natural-draught gas fired boiler. The effect of chimney height on boiler flue gases is being considered to address the need for increasing concern over environmental safety as well as saving of energy. A multi-component analysis computer (DELTA 2000 CD) is used to analyze the flue gases. 3D nu...