Thermal Analysis of a Film Cooling System with Normal Injection Holes Using Experimental Data
نویسندگان
چکیده
منابع مشابه
Shape optimization of impingement and film cooling holes on a flat plate using a feedforward ANN and GA
Numerical simulations of a three-dimensional model of impingement and film cooling on a flat plate are presented and validated with the available experimental data. Four different turbulence models were utilized for simulation, in which SST had the highest precision, resulting in less than 4% maximum error in temperature estimation. A simplified geometry with periodic boundary conditions is de...
متن کاملAn Experimental Study of Momentum-Preserving Shaped Holes for Film Cooling Using PSP and PIV
An experimental investigation was conducted to study the performance of film cooling injection from a cylindrical hole and a “W-shaped” hole. A Pressure Sensitive Paint (PSP) technique was used to map the spatial distribution of film cooling effectiveness on the surface of the test plate based on a mass-transfer analogy. The effects of mass flux ratio and density ratio on film cooling effective...
متن کاملComparing the Efficiency of Dmus with Normal and Skew-Normal Distribution using Data Envelopment Analysis
Data envelopment analysis (DEA) is a nonparametric approach to evaluate theefficiency of decision making units (DMU) using mathematical programmingtechniques. Almost, all of the previous researches in stochastic DEA have been usedthe stochastic data when the inputs and outputs are normally distributed. But, thisassumption may not be true in practice. Therefore, using a normal distribution wi...
متن کاملFilm cooling effectiveness in single row of holes: First moment closure modeling
The present article focuses on the evaluation of a first-moment closure model applicable to film cooling flow and heat transfer computations. The present first-moment closure model consists of a higher level of turbulent heat flux modeling in which two additional transport equations for temperature variance kθ and its dissipation rate εθ are ...
متن کاملSimulation of Film Cooling Enhancement with Mist Injection
Cooling of gas turbine hot section components such as combustor liners, combustor transition pieces, turbine vanes (nozzles) and blades (buckets) is a critical task for improving the life and reliability of hotsection components. Conventional cooling techniques using air-film cooling, impingement jet cooling, and turbulators have significantly contributed to cooling enhancements in the past. Ho...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Fluid Machinery and Systems
سال: 2009
ISSN: 1882-9554
DOI: 10.5293/ijfms.2009.2.1.055