THEORETICAL INVESTIGATIONS ON STANDING WAVE THERMOACOUSTIC PRIME MOVER USING DELTAEC
نویسندگان
چکیده
منابع مشابه
Experimental studies of a thermoacoustic Stirling prime mover and its application to a cooler
An acoustic field spontaneously induced in a thermoacoustic prime mover consisting of a looped tube and resonator is determined through simultaneously measurements of pressure P and velocity U. A thermal efficiency of the thermoacoustic prime mover of this type has been reported to reach 30%. The measurements of the acoustic field in the present system revealed that a phase lead of U relative t...
متن کاملDepartment of Prime Mover Engineering
Technological innovations in the field of prime movers have recently made a rapid progress as represented in cars and engines. In the Department of Prime Mover Engineering, research, design and manufacture are carried out with respect to lean burn engine, alternative fuel engine, electric vehicles such as hybrid cars, linear motor cars by use of magnetic levitation, and energy-saving solar cars...
متن کاملLoad Effect on the Starting Performance of a Standing Wave Thermoacoustic Engine
Introduction A thermoacoustic engine is a device absorbing heat at the hot heat exchanger and releasing heat at the cold heat exchanger while producing acoustic work as an output. Engines are built to carry a load, which in the case of an acoustic device, might include a thermoacoustic refrigerator [4], a (possibly linear) electric generator [2] etc. Coupling between the engine and the load inf...
متن کاملStudy of Standing-Wave Thermoacoustic Electricity Generators for Low-Power Applications
This paper is concerned with the study of low-cost, low-power thermoacoustic electricity generators. Based on target electrical output power values of 50 and 100 W, three standing wave prototypes (of both one-stage and two-stage prototypes) integrating a commercial loudspeaker with different coupling arrangements are conceived. Each stage consists of a square-pore stack sandwiched between hot a...
متن کاملHigh-fidelity simulation of an ultrasonic standing-wave thermoacoustic engine with bulk viscosity effects
We have carried out boundary-layer-resolved, unstructured fully-compressible Navier– Stokes simulations of an ultrasonic standing-wave thermoacoustic engine (TAE) model. The model is constructed as a quarter-wavelength engine, approximately 4 mm by 4 mm in size and operating at 25 kHz, and comprises a thermoacoustic stack and a coin-shaped cavity, a design inspired by Flitcroft and Symko (2013)...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2014
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2014.0304098