Theoretical investigation of sintering process.
نویسندگان
چکیده
منابع مشابه
8YSZ sintering by flash sintering method and evaluation of process parameters
Flash sintering as a new sintering method for sintering of ceramic materials has been studied and effect of various parameter such as flash current density, time of flash and contact paste on properties of flash sintered 8YSZ samples has been investigated. Results showed it is possible to achieve high density in shorter time and lower temperature than conventional sintering methods. Samples cou...
متن کاملStudies on sintering process of synthetic hydroxyapatite.
In this study the effect of sintering process in different temperatures on microstructure and morphological properties of sintered hydroxyapatite (HAp) was investigated. HAp powder was prepared by wet precipitation method from following reagents: Ca(OH)2 + H3PO4 in an alkaline conditions. Thermal analysis (TA), X-Ray diffraction method (XRD), FT-IR spectrometry (FT-IR) and scanning electron mic...
متن کاملStabilize Ash using Clemson's Sintering Process
Innovative Technology Summary Reports are designed to provide potential users with the information they need to quickly determine if a technology would apply to a particular environmental management problem. They are also designed for readers who may recommend that a technology be considered by prospective users. Each report describes a technology, system, or process that has been developed and...
متن کاملExpert System for Sintering Process Control
Sintering is a method that makes powdered materials (such as fine ore or preparation concentrate) into block mass under conditions involving incomplete fusion by heating to high temperature. Its production is sinter which is irregular and porous (FU et al., 1996). The following parts are usually included in sintering process: acceptance and storage of iron-containing raw materials, fuel and flu...
متن کاملExperimental and numerical investigation of the sintering rate of snow
Sintering rates in snow were investigated by measuring changes in penetration resistance with time and by using a numerical snow metamorphism model. Periodic Snow Micro Penetrometer (SMP) measurements were performed on uniform snow samples covering a wide range of densities. The mean penetration resistance of snow increased with time according to a power law with an average exponent of 0.18. Si...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Iron and Steel Institute of Japan
سال: 1984
ISSN: 0021-1583,1881-1183
DOI: 10.2355/isijinternational1966.24.178