Theoretical and experimental characterization for macro-micro friction behaviors of EPDM rubber

response articles: micro and macro analysis

the present study reports an analysis of response articles in four different disciplines in the social sciences, i.e., linguistics, english for specific purposes (esp), accounting, and psychology. the study has three phases: micro analysis, macro analysis, and e-mail interview. the results of the micro analysis indicate that a three-level linguistic pattern is used by the writers in order to cr...

Experimental and theoretical characterization of a new Schiff-base ligand

Here, new N,N′-dipyridoxyl(4,4''-diaminodiphenylether) Schiff-base ligand has been synthesized and characterized by IR, 1H NMR and mass spectrometry. Also, geometry optimization and theoretical assignment of IR spectrum of the ligand have been computed by employing density functional theory (DFT) method. Two pyridine rings and benzene rings in the bridge region are not in the same plane. The ca...

Macro-micro Theoretical Integration: an Unexplored Theoretical Frontier*

Theoretical models for prediction of mechanical behaviour of the PP/EPDM nanocomposites fabricated by friction stir process

In this study, thermoplastic polyolefin elastomeric (TPO) nanocomposites were fabricated by friction stir processing. The effect of different pin geometries on clay dispersion and mechanical properties of the TPO nanocomposite reinforced with 3% wt nanoclay has been first investigated. The optimum pin geometry namely threaded cylindrical pin was then used to fabricate the nanocomposites contain...

simulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water

abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...