Theoretical analysis of solar thermal collector and flat plate bottom reflector with a gap between them
نویسندگان
چکیده
منابع مشابه
Theoretical Model of a Flat Plate Solar Collector Integrated with Phase Change Material
Abstract—The objective of this work was to develop a theoretical model to study the dynamic thermal behavior of a flat plate solar collector integrated with a phase change material (PCM). The PCM acted as a heat source for the solar system during low intensity solar radiation and night. The energy balance equations for the various components of the collector as well as for the PCM were formulat...
متن کاملexergy analysis of a flat plate solar collector in combination with heat pipe
the use of solar collectors in combination with heat pipes is rapidly growing in recent years.heat pipes, as heat transfer components, have undeniable advantages in comparison with other alternatives. the most important advantage is their high rate of heat transfer at minor temperature differences. although there have been numerous studies on the heat analysis or first thermodynamic analysis of...
متن کاملModeling of Flat-Plate Solar Collector Operation in Transient States
Saleh, Ahmad M. M.S.E., Purdue University, May 2012. Modeling Of Flat-Plate Solar Collector Operation in Transient States. Major Professor: Hosni Abu-Mulaweh. Solar energy is becoming an alternative for the limited fossil fuel resources. One of the simplest and most direct applications of this energy is the conversion of solar radiation into heat, which can be used in water heating systems. A c...
متن کاملSensitivity Analysis of the Test Parameters of a Solar Flat Plate Collector for Performance Studies
The BIS test procedure for performance of solar flat plate collectors allows a certain limit of deviation for the control parameters to define the steady state condition. During actual performance studies, sometimes these limits are exceeded. In this paper an attempt has been made to find out the effect on the performance curve of the collector as a result of exceeding this prescribed limit by ...
متن کاملEnergy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector
For a solar thermal system, increasing the heat transfer area can increase the output temperature of the system. However, this approach leads to a bigger and bulkier collector. It will then increase the cost and energy needed to manufacture the solar collector. This study is carried out to estimate the potential to design a smaller solar collector that can produce the same desired output temper...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energy Reports
سال: 2015
ISSN: 2352-4847
DOI: 10.1016/j.egyr.2014.10.004