The Weldability of Cr-Mn Austenits Steel
نویسندگان
چکیده
منابع مشابه
Weldability Investigation of Fine-grained S1100ql Steel
I. Samardžić, Faculty of Mechanical Engineering Slavonski Brod, Croatia, A. Ćorić, Bratstvo, Novi Travnik, Bosnia and Herzegovina, M. Dunđer, Department for Polytechnic, University of Rijeka, Croatia. This paper presents the results of weldability investigation on welded joints made of fine grained high-strength S1100QL steel. The investigations are performed on two welded plates by HV 10 hardn...
متن کاملMicrostructural Effect on the Weldability of 25Cr-35Ni Cast Steel
The 25Cr-35Ni heat resistant steel has been widely used when resistance to oxidation and creep rapture at elevated temperatures is required. In this paper, the microstructural effect on the weldability of this alloy is investigated. The results of this study indicate that this steel has a perfect weldability in the as cast condition but does not possess good weldability in the aged condition. T...
متن کاملThe Effect of Nitrogen on Martensite Formation in a Cr-Mn-Ni Stainless Steel
The influence of nitrogen (0 to 0.27 wtYo) on martensite formation in an experimental low-nickel stainless-steel alloy (Fe-17Cr-7Mn-4Ni) has been investigated. The alloys containing 0.1 wtYo or more nitrogen are fully austenitic at room temperature; those containing less nitrogen consist of a mixture of austenite, martensite and S-ferrite. The alloys containing less than 0.2 wtYo nitrogen are m...
متن کاملMicrostructural Effect on the Weldability of 25Cr-35Ni Cast Steel
The 25Cr-35Ni heat resistant steel has been widely used when resistance to oxidation and creep rapture at elevated temperatures is required. In this paper, the microstructural effect on the weldability of this alloy is investigated. The results of this study indicate that this steel has a perfect weldability in the as cast condition but does not possess good weldability in the aged condition. T...
متن کاملHIGH TEMPERATURE TENSILE PROPERTIES OF NEW FE-CR-MN DEVELOPED STEEL
Nowadays, Ni-free austenitic stainless steels are being developed rapidly and high price of nickel is one of the most important motivations for this development. At present research a new FeCrMn steel was designed and produced based on Fe-Cr-Mn-C system. Comparative studies on microstructure and high temperature mechanical properties of new steel and AISI 316 steel were done. The results ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1947
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.16.245