The Stability of Evaporation Rate by Scanning Electron Beam Evaporation Method.
نویسندگان
چکیده
منابع مشابه
An Electron Beam Heated Evaporation Source
An electron beam evaporator has been assembled, tested and used for deposition of thin nickel films. Flux and deposition rates has been measured with an oscillating quartz crystal monitor (QCM), an ion sensor wire, and visible deposition on a mirror on front of the evaporator. A thin nickel rod of 2 mm diameter was found to improve the pressure in comparison to a 6-mm nickel rod. The flux was t...
متن کاملSilicon nanowires prepared by electron beam evaporation in ultrahigh vacuum
One-dimensional silicon nanowires (SiNWs) were prepared by electron beam evaporation in ultrahigh vacuum (UHV). The SiNWs can be grown through either vapor-liquid-solid (VLS) or oxide-assisted growth (OAG) mechanism. In VLS growth, SiNWs can be formed on Si surface, not on SiO2 surfaces. Moreover, low deposition rate is helpful for producing lateral SiNWs by VLS. But in OAG process, SiNWs can b...
متن کاملUltraflat carbon film electrodes prepared by electron beam evaporation.
A facile method for the preparation of thin-film carbon electrodes by electron beam evaporation onto highly doped silicon is presented. The physical and electrochemical properties of these films both before and after postdeposition pyrolysis are investigated. Raman spectroscopy establishes the amorphous structure of the nonpyrolyzed carbon films and confirms the formation of graphitic carbon af...
متن کاملDiscrete-step evaporation of an atomic beam
We present a theoretical analysis of the evaporative cooling of a magnetically guided atomic beam by means of discrete radio-frequency antennas. First we derive the changes in flux and temperature, as well as in collision rate and phase-space density, for a single evaporation step. Next we show how the occurrence of collisions during the propagation between two successive antennas can be probed...
متن کاملAge Hardening of Ultrafine Grained Al-Ti-Cr Alloys Fabricated by Continuous Electron Beam Evaporation
Supersaturated Al-Ti-Cr alloys were produced by a continuous electron beam evaporation technique. The as-deposited alloy sheets were fcc supersaturated solid solution with an average grain size of about 400 nm. Due to the fine grain size, the hardness of the alloy was as high as 270Hv. The sheet showed age hardening, and the peak hardness of 340Hv was obtained after aging at 623K for 900 s, in ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SHINKU
سال: 1994
ISSN: 0559-8516,1880-9413
DOI: 10.3131/jvsj.37.198