The Sintering Process in Snow
نویسندگان
چکیده
منابع مشابه
Experimental and numerical investigation of the sintering rate of snow
Sintering rates in snow were investigated by measuring changes in penetration resistance with time and by using a numerical snow metamorphism model. Periodic Snow Micro Penetrometer (SMP) measurements were performed on uniform snow samples covering a wide range of densities. The mean penetration resistance of snow increased with time according to a power law with an average exponent of 0.18. Si...
متن کاملDetermining the Snow Coefficient in order to simulate the snow melting in the Shemshak Watershed Using the WetSpa Model
In mountainous regions, snow forms a part of the precipitation. Therefore, snow melting is an important process in hydrology and hydraulic in these areas that its role should be considered independently in runoff generation. The Shemshak watershed basin located in Tehran province was selected as the study area of this research to examine the efficiency of the WetSpa hydrologic model to simulate...
متن کاملStabilize Ash using Clemson's Sintering Process
Innovative Technology Summary Reports are designed to provide potential users with the information they need to quickly determine if a technology would apply to a particular environmental management problem. They are also designed for readers who may recommend that a technology be considered by prospective users. Each report describes a technology, system, or process that has been developed and...
متن کاملExpert System for Sintering Process Control
Sintering is a method that makes powdered materials (such as fine ore or preparation concentrate) into block mass under conditions involving incomplete fusion by heating to high temperature. Its production is sinter which is irregular and porous (FU et al., 1996). The following parts are usually included in sintering process: acceptance and storage of iron-containing raw materials, fuel and flu...
متن کاملStudies on sintering process of synthetic hydroxyapatite.
In this study the effect of sintering process in different temperatures on microstructure and morphological properties of sintered hydroxyapatite (HAp) was investigated. HAp powder was prepared by wet precipitation method from following reagents: Ca(OH)2 + H3PO4 in an alkaline conditions. Thermal analysis (TA), X-Ray diffraction method (XRD), FT-IR spectrometry (FT-IR) and scanning electron mic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Glaciology
سال: 1966
ISSN: 0022-1430,1727-5652
DOI: 10.3189/s0022143000019535