The shaft response characteristics of hydrostatic thrust gas bearings with fluid damper.
نویسندگان
چکیده
منابع مشابه
Differential Quadrature Method for the Analysis of Hydrodynamic Thrust Bearings
This paper presents the application of the method of generalized differential quadrature (GDQ) for the analysis of hydrodynamic thrust bearings. GDQ is a simple, efficient, high-order numerical technique and it uses the information on all grid points to approach the derivatives of the unknown function. The effectiveness of the solution technique is verified by comparing the GDQ computed results...
متن کاملThe Effect of Tuned Mass Damper on Seismic Response of Building Frames with Uncertain Structural Characteristics
Tuned mass dampers (TMDs) could be used to absorb the input energy of the applied load, and reduce the response of the building frames. However, the effectiveness of TMD in reducing the response of the building frames could be affected by inherited uncertainties in the structural characteristics of the frames. In this study, in order to investigate the probabilistic response of steel moment-res...
متن کاملA Computer Based Approach for the Design of the Orifice- Compensated with Feeding Pocket Annular Hydrostatic Thrust Bearings
The orifice-compensated with feeding pocket annular hydrostatic (OCFPAH) thrust bearing is a unique type of gas bearing with many distinguishing characteristics. It is finding many applications in ultra high-speed rotors. A computer code was written to overcome the difficulties involved in the design of such a bearing. Initially, the design charts were converted into the alternative equations u...
متن کاملInertia Effect of the Fluid Particles on the Lubricant Flow in a Dynamic Thrust Bearings
Closed form equations are derived from the fundamental principles for the evaluation of volume flow rate of lubricant in between the pads of a thrust bearing accounting for the centrifugal inertia effect. Two types of configuration i.e. parallel disk and nonparallel disk configurations are considered. The theoretical analysis is presented.
متن کاملComparison of the Dynamic Response of Radial and Tangential Magnetic Flux Thrust Bearings
Theoretical predictions were made for the dynamic performance of a tangential flux magnetic thrust bearing. A prototype bearing was built with the stators and rotors made from tape wound strip. The performance of this bearing was measured and compared to the theoretical predictions and also to the performance of a radial flux thrust bearing. Tangential flux bearings are intrinsically amenable t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1991
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.57.844