The rotating elastic-plastic hollow shaft heated at its inner surface

Infrared transmissive, hollow plastic waveguides with inner Ag-Agl coatings.

Hollow polycarbonate waveguides with thin-film coatings of Ag-AgI were fabricated by liquid-phase chemistry methods. These hollow waveguides, which have bore sizes ranging from 500 to 2000 microm and lengths as long as 2 m, are transmissive from 2 to more than 20 microm. The lowest loss of 0.02 dB/m was obtained for a straight 2000 microm bore guide at 10.6 microm. This is to our knowledge the ...

AXIAL FLOW OF CASSON PLASTIC MODEL IN ANNULUS WITH A ROTATING INNER CYLINDER

Elastic-Plastic Transition in a Thin Rotating Disc with Inclusion

Stresses for the elastic-plastic transition and fully plastic state have been derived for a thin rotating disc with inclusion and results have been discussed numerically and depicted graphically. It has been observed that the rotating disc with inclusion and made of compressible material requires lesser angular speed to yield at the internal surface whereas it requires higher percentage increas...

Elastic-plastic Deformation at Finite Strains

In some circumstances, elastic-plastic deformation occurs in which both components of strain are finite. Such situations fall outside the scope of classical plasticity theory which assumes either infinitesimal strains or plastic-rigid theory for large strains. The present theory modifies the kinematics to include finite elastic and plastic strain components. For situations requiring this genera...

Convective Heat Transfer from a Heated Rotating Disk at Arbitrary Inclination Angle in Laminar Flow

In this paper, experimental data and numerical results of heat transfer from a heated rotating disk in still air are presented over a large range of inclination angles and a dimensionless correlation is developed for forced, natural and mixed convection. The measured Nusselt number over the rotating disk is compared with the numerical results. The goal of the present research is to develop a se...