The relationships between cutting parameters, tool wear, cutting force and vibration
نویسندگان
چکیده
منابع مشابه
Investigating Flank Wear and Cutting Force on Hard Steels by CBN Cutting Tool by Turning
In this research work a series of tests were conducted in order to determine flank wear and cutting force FY on hard AISI 440 C martensitic stainless steel and SCM 440 alloy steels. The operating parameters are cutting speed, feed rate and a constant depth of cut to investigate the flank wear and cutting force. No cutting fluid was used during the turning process. The cutting tool used was CBN ...
متن کاملOn the Physics of Machining Titanium Alloys: Interactions between Cutting Parameters, Microstructure and Tool Wear
The current work deals with the analysis of mechanisms involved during the machining process of titanium alloys. Two different materials were chosen for the study: Ti-6Al-4V and Ti-55531. The objective was to understand the effect of all cutting parameters on the tool wear behavior and stability of the cutting process. The investigations were focused on the mechanisms of the chip formation proc...
متن کاملThe Impact of Cutting Tool Materials on Cutting Force
A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. In the present study, an attempt has been made to investigate the effect of cutting tool materials on cutting forces (feed force, thrust force and cutting force) in finish hard turning of AISI D2 cold work tool steel. In conclusion of the results obtained with...
متن کاملVibrations, Shocks and Noise Tool wear criterion based on cutting tool vibration
This work presents a new criterion for the tool wear evaluation from cutting tool vibration. The vibratory signatures produced during a dry turning process were acquired using a three-axis accelerometer mounted on cutting tool. Then, the mean power analysis was estimated to extract an indicator parameter able to describe the wear of the cutting tool along its lifespan. Finally, a criterion base...
متن کاملCutting tool wear estimation for turning
The experimental investigation on cutting tool wear and a model for tool wear estimation is reported in this paper. The changes in the values of cutting forces, vibrations and acoustic emissions with cutting tool wear are recoded and analyzed. On the basis of experimental results a model is developed for tool wear estimation in turning operations using Adaptive Neuro fuzzy Inference system (ANF...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2018
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814017750434