The Recovery of Potash from Blast-Furnace Gases
نویسندگان
چکیده
منابع مشابه
The Study of Ion Adsorption by Amorphous Blast Furnace Slag
In this study, the blast furnace slag was used as absorbing bed and then, its ionic adsorption was studied. For this reason, various experimental parameters such as pH, contact time and the primary ion concentration were investigated. The remaining concentrations of ions such as; Mn2+ and Fe2+ in water were measured by atomic adsorption spectroscopy. The chemical and p...
متن کاملGround Granulated Blast Furnace Slag
1. Ground Granulated Blast Furnace Slag Ground Granulated Blast Furnace Slag (GGBFS) is a by product of the steel industry. Blast furnace slag is defined as “the non-metallic product consisting essentially of calcium silicates and other bases that is developed in a molten condition simultaneously with iron in a blast furnace.” [1] In the production of iron, blast furnaces are loaded with iron o...
متن کاملBlast furnace slags as sorbents of phosphate from water solutions.
The paper is focused on the sorption of phosphorus from aqueous solutions by crystalline and amorphous blast furnace slags. Slag sorption kinetics were measured, adsorption tests were carried out and the effect of acidification on the sorption properties of slags was studied. The kinetic measurements confirmed that the sorption of phosphorus on crystalline as well as amorphous slags can be desc...
متن کاملThe Effect of Recovery Furnace
A commercially available computational fluid dynamics code has been used to simulate temperature and flow profiles in the upper, convective heat transfer region of a recovery boiler for different bullnose designs. The convective heat transfer region of the furnace was simulated by examining a zone that begins below the bullnose and ends at the economizer. Superheater tubes and a boiler bank wer...
متن کاملCeramics from blast furnace slag, kaolin and quartz
Three new ceramic batches with no traditional fluxes and 30, 50 and 70 wt.% blast furnace slag were studied. The processes of phase formation and densification were estimated in non-isothermal conditions by differential thermal analysis and dilatometry, respectively. After that the degrees of sintering, obtained after heat-treatment at different temperatures and times, were evaluated measuring ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nature
سال: 1918
ISSN: 0028-0836,1476-4687
DOI: 10.1038/101147a0