The properties and fabrication of metal matrix composites.
نویسندگان
چکیده
منابع مشابه
Design, Fabrication, and Properties of High Damping Metal Matrix Composites—A Review
Nowadays it is commonly considered that high damping materials which have both the good mechanical properties as structural materials and the high damping capacity for vibration damping are the most direct vibration damping solution. In metals and alloys however, exhibiting simultaneously high damping capacity and good mechanical properties has been noted to be normally incompatible because the...
متن کاملFabrication and properties of composites of
Carbon nanotubes (CNTs) [1, 2] have dimensions similar to those of typical polymeric chains, with 1-50nm in diameter and 1-10µm in length. Experimental results on individual carbon nanotubes and nanotube bundles show that they have exceptional electrical and mechanical properties with an elastic modulus of ~1TPa and fracture strain of 5-10%. [3] The thermal conductivity of the nanotubes is expe...
متن کاملBasics of Metal Matrix Composites
Metal composite materials have found application in many areas of daily life for quite some time. Often it is not realized that the application makes use of composite materials. These materials are produced in situ from the conventional production and processing of metals. Here, the Dalmatian sword with its meander structure, which results from welding two types of steel by repeated forging, ca...
متن کاملAn Investigation of the Use of Ni3Al Intermetallic Compound for Fabrication of Al Matrix Composites
Fabrication and characterization of aluminum matrix composites containing different volume fractions of Ni3Al powder (5-40 Vol%) were investigated. Ni3Al powder was produced by mechanical alloying of elemental nickel and aluminum powder mixture. Al-Ni3Al composite parts were prepared using a powder metallurgy route involving two stages Al and Ni3Al powder mixtures were first compacted under 500...
متن کاملAn Investigation of the Use of Ni3Al Intermetallic Compound for Fabrication of Al Matrix Composites
Fabrication and characterization of aluminum matrix composites containing different volume fractions of Ni3Al powder (5-40 Vol%) were investigated. Ni3Al powder was produced by mechanical alloying of elemental nickel and aluminum powder mixture. Al-Ni3Al composite parts were prepared using a powder metallurgy route involving two stages Al and Ni3Al powder mixtures were first compacted under 500...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the Japan Institute of Metals
سال: 1990
ISSN: 0021-4426,1884-5835
DOI: 10.2320/materia1962.29.91