The Mechanism of Three-dimensional Cutting Operations (Part 6)
نویسندگان
چکیده
منابع مشابه
The three-dimensional structure of nylon hydrolase and the mechanism of nylon-6 hydrolysis*
From the Department of Materials Science and Chemistry, Graduate School of Engineering, University of Hyogo, Hyogo 671-2280; Department of Life Science, Graduate School of Life Science, University of Hyogo, Hyogo 678-1297; RIKEN Harima Institute, SPring-8 Center, Hyogo 679-5148; Institute for Protein Research, Osaka University, Osaka 565-0871, Department of Intelligence Mechanical Technology, G...
متن کاملThree Graceful Operations
A graph of size n is said to be graceful when is possible toassign distinct integers from {0, 1, . . . , n} to its verticesand {|f(u)−f(v)| : uv ∈ E(G)} consists of n integers. Inthis paper we present broader families of graceful graphs; these families are obtained via three different operations: the third power of a caterpillar, the symmetric product of G and K2 , and the disjoint union of G a...
متن کاملthree-dimensional slope stability analysis with rotational failure mechanism
this paper deals with three-dimensional evaluation of the slopes on the basis of limit analysis. an upper-bound technique of limit analysis is used in this paper to determine either the bearing capacity of a shallow foundation near a slope or the safety factor of the slope. the theorems of limit analysis (upper and lower bound) provide a powerful tool for solving problems in which limit loads n...
متن کاملOn the 6 ́6 stiffness matrix for three dimensional motions
In this paper, methods of differential geometry and properties of Lie groups are used to show that in any conservative system subjected to a non zero external load, if one examines motions in SE(3), the special Euclidean group of rigid body motions in three dimensions, the resulting 6 ́6 stiffness matrix is asymmetric in any inertial (fixed) or body-fixed reference frame. We prove that in any su...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Precision Engineering
سال: 1968
ISSN: 0374-3543
DOI: 10.2493/jjspe1933.34.524