The investigation of using phase change material for solar pond insulation

نویسندگان

چکیده

Solar ponds are systems that store solar energy in salt water as heat energy. In order to for a long time pond, the insulation should be done well. this study, effect of phase change materials was investigated improve pond and longer time. The melting temperature is key parameter selection materials. distribution examined with temperatures range average ?10?C were selected. Three different used walls insulation. enthalpy changes system calculated numerically year. storage ratio determined by using obtained radiation data. Consequently, glass-wool maximum 20.95% July minimum 7.92% January. which paraffin C18, capric acid 44 32.22%, 34.85%, 47.81% December, respectively. It observed appropriate provided ponds.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

the use of appropriate madm model for ranking the vendors of mci equipments using fuzzy approach

abstract nowadays, the science of decision making has been paid to more attention due to the complexity of the problems of suppliers selection. as known, one of the efficient tools in economic and human resources development is the extension of communication networks in developing countries. so, the proper selection of suppliers of tc equipments is of concern very much. in this study, a ...

15 صفحه اول

Experimental investigation on the effect of phase change materils (PCM) in solar compression refrigeration cycle efficiency

Saving energy is one of the most important challenges of todaychr('39')s world. Reducing electrical energy consumption in compressed air systems is one of the essential requirements for designing these systems. When using domestic air conditioners (dual air conditioners) in very hot areas (Khuzestan) their performance decreases and electric current consumption increases. Therefore, the use of n...

متن کامل

Effect of Using Nano Encapsulated Phase Change Material on Thermal Performance of Micro Heat Sink

The aim of this paper is to enhance thermal performance of a microchannel heat sink by using nanoencapsulated phase change material (NEPCM) slurry as a cooling fluid instead of pure fluid. A threedimensional model of a circular channel using water slurry of NEPCM was developed. The results show a significant reduction in the mean fluid temperature along the channel and heat sink wall temperatu...

متن کامل

Microencapsulation of Butyl Stearate as Phase Change Material by Melamine Formaldehyde Shell for Thermal Energy Storage

Butyl stearate as a phase change material was microencapsulated within melamine-formaldehyde resin using emulsion polymerization. Morphology and thermal specification of produced microcapsules were studied by Fourier transform infrared spectroscopy, FT-IR, scanning electron microscopy, SEM, and Differential scanning calorimetry analysis, DSC. FT-IR spectra validated the existence of the butyl s...

متن کامل

Off - Peak Cooling Using Phase Change Material

The electric utilities in the United States are faced with continued rapid growth in electrical demand. The traditional response to growth in demand has been the expansion of generating capacity. However , economic, environmental, and scheduling constraints will combine to make adequate expansion difficult, if not impossible, in the 1980's. This thesis examines load management as an alternative...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Thermal Science

سال: 2022

ISSN: ['0354-9836', '2334-7163']

DOI: https://doi.org/10.2298/tsci210309185b