The Interfacial Transition Zone in Alkali-Activated Slag Mortars

The Interfacial Transition Zone in Alkali-Activated Slag Mortars

The interfacial transition zone (ITZ) is known to strongly influence the mechanical and transport properties of mortars and concretes. This paper studies the ITZ between siliceous (quartz) aggregates and alkali-activated slag (AAS) binders in the context of mortar specimens. Backscattered electron (BSE) images generated in an environmental scanning electron microscope (ESEM) are used to identif...

PROPERTIES OF ALKALI-ACTIVATED FLY ASH CONCRETE BLENDED WITH SLAG

Interfacial transition zone characterization of Portland cement mortars containing relatively high dosages of polynaphthalene sulfonate superplasticizers

The microstructure and interfacial transition zone characteristics of Portland cement mortars prepared with a polynaphthalene sulfate (PNS) superplasticizer at relatively high dosages (0.8%, 1.5% by mass of cement) and varying sand-to-cement ratios (0.5, 1.0, 1.5) were investigated, using AC impedance spectroscopy, mercury intrusion porosimetry, helium pycnometry and two electrical conductance ...

Handbook of Alkali-Activated Cements, Mortars and Concretes

6.

SELF-Cured Alkali Activated Slag Concrete Mixes- An Experimental Study

Alkali Activated Slag Concrete (AASC) mixes are manufactured by activating ground granulated blast furnace slag (GGBFS) using sodium hydroxide and sodium silicate solutions. The aim of the present experimental research was to investigate the effect of increasing the dosages of sodium oxide (Na2O, in the range of 4 to 8%) and the activator modulus (Ms) (i.e. the SiO2/Na2O ratio, in the range of ...