The Ideal Tooth Profiles of Conical-External and -Internal Gears Meshing with Cylindrical-Involute Gears over the Entire Tooth Width.
نویسندگان
چکیده
منابع مشابه
Bending strength simulation of asymmetric involute tooth gears
In order to enhance the load capacity of gears, researchers take notice in the asymmetric tooth gears. Asymmetric gear which has higher pressure angle of back tooth aiming to improve banding strength has been analyzed (Deng, et al., 2003). Brown et al. (Brown, et al., 2010) investigate the asymmetric tooth from both point of view of bending and scuffing. Kruger et al. (Kruger et al., 2013) anal...
متن کاملDesign, Meshing Characteristics and Stress Analysis of Cylindrical Gears with Curvilinear Tooth Profile
Curvilinear tooth gears are commonly produced on a face milling cutter and a hob cutter. However, this paper proposes a kind of curvilinear tooth gear which is processed by a parallel linkage with a single blade cutter. For the purpose of identifying the meshing and contact characteristics of curvilinear tooth gears, the paper covers the following: (i) equations of tooth surfaces are deduced fr...
متن کاملModal Analysis of Cylindrical Gears with Arcuate Tooth Trace
In this paper, the forming principle, meshing features and tooth surface equation were introduced. And the modal parameters distribution of cylindrical gears with arcuate tooth trace was researched. The results show: 1. The modulus was the biggest impact factor for modal and natural frequency of cylindrical gears with arcuate tooth trace, then tooth width, and the radius of tooth line have the ...
متن کاملCutting Kinematics Analysis in Hypocycloidal Tooth Milling of Cylindrical Gears
The hypocycloidal flanks of the cylindrical gear teeth have the flank lines defined by lengthened or shortened hypocycloid and the profile involute. The curved and bulged flanks have some advantages, among them being the increased strength in bending and controlled positioning of the contact imprint. The tooth flank generation has on the basis the application of the technological process of mil...
متن کاملOptimal Selection of Addendum Modification Coefficients of Involute Cylindrical Gears
Based on the principles of equalized sliding coefficients and equalized teeth bending strength, the optimization mathematical model for calculating and allocating the addendum modification coefficients of involute cylindrical gear is firstly established. Then the measures to calculate the tooth parameters in real-time during the optimization steps are achieved. Finally, the optimization program...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME International Journal Series C
سال: 1998
ISSN: 1344-7653,1347-538X
DOI: 10.1299/jsmec.41.901