The Foamed Metal Structures in Numerical Testing
نویسندگان
چکیده
منابع مشابه
Numerical modeling of pore size and distribution in foamed titanium
To facilitate the design and development of porous metals, simulation of their mechanical behavior is essential. As an alternative to complex tomography procedures, a methodology has been developed to construct a simulated microstructure that retains the essential features of the experimental material. The target material is a moderate porosity titanium foam that is being developed as a bone im...
متن کاملthe algorithm for solving the inverse numerical range problem
برد عددی ماتریس مربعی a را با w(a) نشان داده و به این صورت تعریف می کنیم w(a)={x8ax:x ?s1} ، که در آن s1 گوی واحد است. در سال 2009، راسل کاردن مساله برد عددی معکوس را به این صورت مطرح کرده است : برای نقطه z?w(a)، بردار x?s1 را به گونه ای می یابیم که z=x*ax، در این پایان نامه ، الگوریتمی برای حل مساله برد عددی معکوس ارانه می دهیم.
15 صفحه اولNumerical Modelling of the Segmental Lining of Underground Structures
There are several methods for analysing the behaviour of underground structures under different loading conditions. Most of these methods have many simplifications; therefore, in some cases, the results are too conservative and a very high safety factor, usually of more than 2 is needed. On the other hand, for stability analysis and the designing of support systems, these methods consider segme...
متن کاملNumerical Analysis of Metal Transfer in Gas Metal Arc Welding
METAL transfer describes the process of the molten metal movement from the electrode tip to the workpiece in gas metal arc welding (GMAW). A better understanding of the metal transfer process is important for improvements in the quality and productivity of welding. While several distinct modes of the metal transfer have been classified,[1] the globular and spray transfer modes have received att...
متن کاملCompression testing of foamed plastics and rubbers for use as orthotic show insoles.
Thirty-one materials have been tested in compression in order to generate the stress (force per unit of cross-sectional area) versus strain (deformation) behaviour, for the purpose of assessing the suitability of various foamed plastics and rubbers as shoe insole materials. It was found that the materials could be classified into three distinct categories (very stiff, moderately deformable and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanics
سال: 2018
ISSN: 2029-6983,1392-1207
DOI: 10.5755/j01.mech.24.1.20213