The fluidized bed reactor with a prepolymerization system and its influence on polymer physicochemical characteristics

Influence of biomass accumulation on bed expansion characteristics of a down-flow anaerobic fluidized-bed reactor.

This article describes the bed expansion characteristics of a down-flow anaerobic fluidized bed reactor treating a synthetic wastewater. Experiments were carried out in a 0.08 m diameter and 1 m length PVC column. The carrier used was ground perlite (an expanded volcanic rock). Particles characteristics were 0.968 mm in diameter, specific density of 213 kg x m-3 and Umf (minimal fluidization ve...

Control of a Fluidized Bed Polyethylene Reactor

In present paper, dynamic behavior and control of a fluidized bed reactor for polyethylene production has been considered. A double active sites model for Ziegler-Natta catalysts is used for simulation of polymerization reaction. Hydrodynamic behavior of the bed is modeled using a two phase model including bubble and emulsion phases in which bubble phase has plug flow pattern with different...

Fluidization Characteristics of a Prototype Fluidized Bed Reactor

The fluidization characteristics of a prototype-fluidized bed laboratory reactor were understudied in order to investigate the suitable conditions at which the dehydrogenation reaction of butane could be carried out. To achieve this, a reactor with an effective volume of 1100ml was fabricated and coupled with temperature and pressure accessories. Zeolites were obtained from the market and clay ...

Characteristics of a Methanogenic Biofilm on Sand Particles in a Fluidized Bed Reactor

−− The typical microbiological groups reported in literature under the experienced environmental conditions are present in the biofilm structure investigated on sand particles. This is concluded based on microorganism morphology analyzed by scanning electron microscopy. Methanosarcina sp. (acetate consumers) and filamentous microorganisms with morphology similar to Methanospirillum sp. (H2-util...

Unsteady-State Modeling of the Fluidized Bed Polyethylene Reactor