The Flow Properties and Curing Behaviors in Mold and Mold Design
نویسندگان
چکیده
منابع مشابه
Numerical Modeling of Mold Filling and Curing in Non-Isothermal RTM Process (RESEARCH NOTE)
Resin Transfer Molding (RTM) is a composite manufacturing process. A preformed fiber is placed in a closed mold and a viscous resin is injected into the mold. In this paper, a model is developed to predict the flow pattern, extent of reaction and temperature change during filling and curing in a thin rectangular mold. A numerical simulation is presented to predict the free surface and its inter...
متن کاملAn Investigation on Mold Powders Properties Consumed in Iran
This paper describes the work done between IUST and two Iranian steelworks to evaluate and review the performance of mould fluxes in current use for continuous casting. Calculations have been performed to compare actual values of powder consumption, viscosity and break temperature of the fluxes in current use with required values derived from published empirical rules for casting conditions....
متن کاملEffect of chitosan on the mold resistance of wood and its surface properties
In this study, the effect of soluble chitosan, thyme oil and linseed oil on the mold resistance of wood and its surface properties was investigated. Both low and medium molecular weight chitosan with concentration of 1 and 2% were used. Cypress wood samples with dimensions of 20 × 20 × 70 mm and moisture content of 12% were saturated by the preservatives. The results showed that the maximum abs...
متن کاملMODELING SURFACE TENSION AND WALL ADHESION IN MOLD FILLING PROCESS
Abstract: In this study an algorithm for mold-filling simulation with consideration of surface tension has been developed based on a SOLA VOF scheme. As the governing equations, the Navier-Stokes equations for incompressible and laminar flows were used. We proposed a way of considering surface tension in mold-filling simulation. The proposed scheme for surface tension was based on the conti...
متن کاملHow to reduce mold design time
This book is authored by a group of individuals who have published several important papers in the area of injection mold design and are quite knowledgeable in the field. They belong to a select group of academicians who have successfully commercialized the software developed in their laboratory. Overall, I found this book to be easy to read and full of useful information. This book should be a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: NIPPON GOMU KYOKAISHI
سال: 2009
ISSN: 0029-022X
DOI: 10.2324/gomu.82.316