The ε Phase Formation Range of Fe-C-Mn Alloys under Quenched Conditions
نویسندگان
چکیده
منابع مشابه
Effect of Mn and Fe on the Formation of Fe- and Mn-Rich Intermetallics in Al–5Mg–Mn Alloys Solidified Under Near-Rapid Cooling
Mn was an important alloying element used in Al-Mg-Mn alloys. However, it had to be limited to a low level (<1.0 wt %) to avoid the formation of coarse intermetallics. In order to take full advantage of the benefits of Mn, research was carried out to investigate the possibility of increasing the content of Mn by studying the effect of cooling rate on the formation of Fe- and Mn-rich intermetall...
متن کاملtransformation in metastable Fe - Mn alloys
Metastable Fe-Mn alloys exhibit a non-thermoelastic martensitic transformation which is accompanied by a significant thermal effect (ca. 20 J/g). Among Fe-Mn alloys, the highest value of latent heat was registered in alloys with 17-18 wt. % Mn. In this work we investigate effects of carbon (up to 0.4 wt. %) and cold rolling (5-25% of thickness reduction) on the latent heat and the temperature h...
متن کاملPhase Diagrams of Fe-Si Alloys under High Pressures
Introduction Iron is the most abundant element in the Earth’s core. However, the density of the outer core is about 10% lower than the density of iron at the pressure and temperature conditions of the outer core, indicating the presence of a low-atomic-weight component (such as H, C, O, Si, or S) in the core [1]. There is also evidence that the inner core may be less dense than pure iron and th...
متن کاملMechanical behaviour of Fe-C alloys during phase transformations
The mechanical behaviour of Fe-C aiioys have been determined in their phase transformation ranges during isothermal or anisothermal transformations. Two models an analytical model and a fii te element model have been used in order to calculate the behaviour of the material. Considering a macroscopic scale, these models show that the mechanical behaviour can be well described when an additional ...
متن کاملFe–Al–Mn–C lightweight structural alloys: a review on the microstructures and mechanical properties
Adding a large amount of light elements such as aluminum to steels is not a new concept recalling that several Fe-Al-Mn-C alloys were patented in 1950s for replacement of nickel or chromium in corrosion resistance steels. However, the so-called lightweight steels or low-density steels were revisited recently, which is driven by demands from the industry where steel has served as a major structu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Institute of Metals
سال: 1965
ISSN: 0021-4434,2432-4701
DOI: 10.2320/matertrans1960.6.240