The economics of flue gas cooling technology for coal-fired power stations with flue gas desulfurisation
نویسندگان
چکیده
منابع مشابه
Flue Gas Cooling
When waste heat is not utilized, cooling of flue gases in special cooling chambers becomes necessary, if the dust':'collecting and associated equipment is constructed of metal. The two most common methods of cooling are by dilution with ambient air, and by evaporation of water in the gas stream. Usually, they are combined. Load sharing depends largely on acceptable visibility of stack effluvia ...
متن کاملUsing bromine gas to enhance mercury removal from flue gas of coal-fired power plants.
Bromine gas was evaluated for converting elemental mercury (Hg0) to oxidized mercury, a form that can readily be captured by the existing air pollution control device. The gas-phase oxidation rates of Hg0 by Br2 decreased with increasing temperatures. SO2, CO, HCl, and H2O had insignificant effect, while NO exhibited a reverse course of effect on the Hg0 oxidation: promotion at low NO concentra...
متن کاملNovel catalytic process for flue gas conditioning in electrostatic precipitators of coal-fired power plants.
One of the most important environmental protection problems for coal-fired power plants is prevention of atmospheric pollution of flying ash. The ash particles are typically removed from flue gases by means of electrostatic precipitators, for which the efficiency may be significantly increased by lowering the resistance of fly ash, which may be achieved by controlled addition of microamounts of...
متن کاملMicrostructure contradistinction for indirect/direct desulfurization product layer of limestone particle in coal-fired flue gas
The micro morphology of limestone sorbent is a key for improving the SO2 removal efficiency in the coal-fired power plant. The tube furnace system was built for imitating the indirect desulfurization reaction in traditional boiler atmosphere (65%N2, 15%CO2, 4.7%O2, 15%H2O, 0.3%SO2) and the direct desulfurization reaction in oxygen-fired atmosphere (80%CO2, 4.7%O2, 15%H2O, 0.3%SO2). The reacted ...
متن کاملIncreasing Cooling Towers Heat Capacity by Flue Gas Introduction
In this paper the changes in the heat capacity of cooling towers has been investigated as a result of injecting combustion products of boilers. In the tower, the air is re-heated through mixing with hot flue gas after passing through the heat exchangers. As a result of this process, the draft of the cooling tower is increased. The additional produced draft depends on the ambient temperature and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Clean Air Journal
سال: 2018
ISSN: 2410-972X,1017-1703
DOI: 10.17159/2410-972x/2018/v28n1a8