THE DRY SPINNING OF POLYACRYLONITRILE SOLUTION

Drawing dependent structures, mechanical properties and cyclization behaviors of polyacrylonitrile and polyacrylonitrile/carbon nanotube composite fibers prepared by plasticized spinning.

Drawing to change the structural properties and cyclization behaviors of the polyacrylonitrile (PAN) chains in crystalline and amorphous regions is carried out on PAN and PAN/carbon nanotube (CNT) composite fibers. Various characterization methods including Fourier transform infrared spectroscopy, differential scanning calorimetry, X-ray diffraction and thermal gravimetric analysis are used to ...

Exploring the Thermodynamic Aspects of Structure Formation During Wet-Spinning of Polyacrylonitrile Fibres

Wet-spun polyacrylonitrile fibres are the main precursor for high strength carbon fibres. The properties of carbon fibres strongly depend on the structure of the precursor fibre. Polyacrylonitrile fibres were spun from solutions with varying solvent/nonsolvent content and different draw ratios. Wet-spinning is an immersion precipitation process, thus thermodynamic affinity of spinning dope to t...

Comparison of the Anti-Fungal Effect of Electro-Spinning Drug-Loaded Nano-Fibers and Pad Dry Drug-Loaded Fabrics

Polymethylmethacrylate/Polyacrylonitrile Membranes via Centrifugal Spinning as Separator in Li-Ion Batteries

Electrospun nanofiber membranes have been extensively studied as separators in Li-ion batteries due to their large porosity, unique pore structure, and high electrolyte uptake. However, the electrospinning process has some serious drawbacks, such as low spinning rate and high production cost. The centrifugal spinning technique can be used as a fast, cost-effective and safe technique to fabricat...

Preparation and Properties of Gelatin Fibers Fabricated by Dry Spinning

Gelatin fibers have been prepared by dry spinning based on the sol-gel transition phenomena of aqueous gelatin solutions. This method is simple and environmentally friendly because only water is used for the spinning, thereby avoiding the use of any toxic organic solvents. A sol-state aqueous solution of gelatin at 50 ̋C was extruded into air through a thin nozzle at room temperature followed b...