THE DESIGN & SIMULATION OF LOW NOISE AMPLIFIER FOR 1 -2.8 GHZ USING ALN SUBSTRATE
نویسندگان
چکیده
منابع مشابه
Design and Fabrication of a 911 GHz Balanced Low Noise Amplifier Using HJFET
This paper describes the design of an X-band balanced low noise amplifier (LNA) using an available HJFET device. The balanced LNA consists of a pair of electrically similar transistors whose input and output signals are divided or combined by 3 dB two-stage Wilkinson power dividers. The proposed balanced LNA is fabricated and measured. The measured results show that the noise figure is 1.30 dB ...
متن کاملA 1.8 GHz CMOS Low-Noise Amplifier
A 1.8 GHz low-noise amplifier has been designed and fabricated in a standard 0.35 pm CMOS process. Measurement results indicate that the amplifier has a forward gain (S21) of 10.5 dB and a noise figure of 3.94 dB, while consuming 40 mW from a 2.5 V supply.
متن کاملA 155=GHz Monolithic Low Noise Amplifier
This paper presents the design, fabrication and performance of a three-stage 155GHz monolithic low noise amplifier (LNA) using 0.1 -pm pseudomorphic (PM) InAIAs/InGaAs/InP HEMT technology. This amplifier exhibits a measured small signal gain of 12 dB at 155 GHz, and more than 10 dB gain from 151 to 156 GHz. When this amplifier is biased for low noise figure, a noise figure of 5.1 dB with associ...
متن کاملA 1.9 GHz Low Noise Amplifier
This paper describes a 1.9 GHz, 25 mW , 0.25 μm CMOS Low Noise Amplifier (LNA), intended for use in a DECT (Digital Enhanced Cordless Communications) Receiver. The LNA has been simulated with Cadence Spectre and the results show that it provides a gain of more than 15 dB, for a noise figure of 2dB, and an input referred IP3 of −5dBm. We present the LNA architecture and the circuit analysis alon...
متن کاملDesign and Implementation of a 1-5 GHz UWB Low Noise Amplifier in 0.18 μm CMOS
This paper presents a compact two-stage ultrawideband low-noise amplifier (LNA). A common-gate topology is adopted for the input stage to achieve wideband input matching, while a cascode stage is used as the second stage to provide power gain at high frequencies. A low power consumption and a small chip area are obtained by optimizing the performance of the LNA with tight constraint on biasing ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Research in Engineering and Technology
سال: 2015
ISSN: 2321-7308,2319-1163
DOI: 10.15623/ijret.2015.0411056