The Cutting Process Instantaneous Stop Device
نویسندگان
چکیده
منابع مشابه
Stop-flow lithography in a microfluidic device.
Polymeric particles in custom designed geometries and with tunable chemical anisotropy are expected to enable a variety of new technologies in diverse areas such as photonics, diagnostics and functional materials. We present a simple, high throughput and high resolution microfluidic method to synthesize such polymeric particles. Building off earlier work that we have done on continuous flow lit...
متن کاملExperimental Study of the Effect of Laser-Cutting Process Parameters on Heat Distribution and Cutting Edge Quality of Steel Sheets
This study aimed to evaluate Laser-cutting process of Mild Steel St37 sheets with two different thicknesses. In order to evaluate the quality of cutting edge and the depth of the area affected by the heat, several tests were conducted to determine the effect of parameters such as Laser power, Laser beam movement speed and pressure of axillary gas on the quality of cutting edge and the depth of ...
متن کاملLight Stop and the b → sγ Process
A constraint from b → sγ process to the minimal supersymmetric standard model is derived in the light stop region where the coupling between the lighter stop and the Z boson vanishes due to the left-right mixing of the stop states. It is pointed out that although some region in the parameter space is excluded from this process there remains a large parameter space where the amplitude of the b →...
متن کاملPerformance Analysis Of Mono-bit Digital Instantaneous Frequency Measurement (Difm) Device
Instantaneous Frequency Measurement (IFM) devices are the essential parts of anyESM, ELINT, and RWR receiver. Analog IFMs have been used for several decades. However, thesedevices are bulky, complex and expensive. Nowadays, there is a great interest in developing a wideband, high dynamic range, and accurate Digital IFMs. One Digital IFM that has suitably reached allthese requirements is mono-bi...
متن کاملChaos in a Cutting Process
The dynamics of the cutting process are investigated. Using the increase of cutting depth as a control parameter, two diierent cutting regimes are observed. In the rst regime, which is observed at small cutting depths, complex, high-dimensional dynamics occur. In the second cutting regime, observed for deeper cuts, low dimensional dynamics are typical. The second cutting regime is usually ident...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Science and Education of the Bauman MSTU
سال: 2016
ISSN: 1994-0408
DOI: 10.7463/0816.0842959