The Characteristics and Behavior of Low Voltage Apparatuses to Voltage Variation
نویسندگان
چکیده
منابع مشابه
Low-Voltage and Low-Power CMOS Voltage-to-Current Converter
A CMOS voltage-to-current converter in weak inversion is presented in this Letter. It can operate for low supply voltage and its power consumption is also low. As the input voltage varies from −0.15 V to 0.15 V, the measured maximum linearity error for the proposed voltageto-current converter, is about 3.35%. Its power consumption is only 26 μW under the supply voltage of 2 V. The proposed volt...
متن کاملDesign of A Low - Voltage and Low - Power Voltage Mode
A low-voltage and low-power voltage mode adder/subtractor using MOSFETs in weakinversion is presented in this paper. Since the MOSFETs in the proposed circuit are biased in weak inversion, consequently its power dissipation is very low. The proposed circuit has been simulated with the HSPICE using a N-well 0.35μm 2p4m process and the results show that, under the supply voltage of 1V, the power ...
متن کاملCharacteristics of the Interferences in a Low Voltage Network*
The paper proposes an approach to investigate the fine structure of the voltages circulating in the industrial network within the range of 300 kHz-20 MHz, which serves to do some measurements of real lines in real operating mode. It is shown that the interferences can be divided into basic with spectral density changing slowly with frequency alteration and narrow-band (frequency-pulse). It is...
متن کاملSimulation of Combined Boost Converter Behavior with Positive Output Voltage and Investigation of Voltage Ripple at Output
In this paper, the behavior of a hybrid back-boost converter with a positive output voltage is simulated. This converter consists of an amplifier voltage converter called KY converter and a modified synchronous converter (SR). The converter operates in continuous conduction mode (CCM) and has a non-shock output current, reducing the current stress in the output capacitor and reducing the output...
متن کاملLow Voltage Ride Through Enhancement Based on Improved Direct Power Control of DFIG under Unbalanced and Harmonically Distorted Grid Voltage
In the conventional structure of the wind turbines along with the doubly-fed induction generator (DFIG), the stator is directly connected to the power grid. Therefore, voltage changes in the grid result in severe transient conditions in the stator and rotor. In cases where the changes are severe, the generator will be disconnected from the grid and consequently the grid stability will be attenu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1996
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1990.116.4_502