The bunch compression system at the TESLA test facility FEL
نویسندگان
چکیده
منابع مشابه
Bunch Compressor Ii at the Tesla Test Facility
In the TESLA Test Facility (TTF), short bunches with low emittance are needed for the operation of a free electron laser. Several stages of bunch compression by means of magnetic chicanes will be used to reach the required peak current. The second stage of the bunch compression system, bunch compressor II, has been taken into operation recently. We describe design and instrumentation of the bun...
متن کاملCavity-type Beam Position Monitors for the SASE FEL at the TESLA Test Facility
Cavity-type beam position monitors were developed to measure the beam alignment at the undulator section of DESY’s TESLA Test Facility (TTF). This paper describes some theoretical aspects and the experimental setup. The results of some in-beam measurements at the TTF are presented and pros and cons of the monitor concept are discussed.
متن کاملEfficient frequency doubler for the soft X-ray SASE FEL at the TESLA Test Facility
This paper describes an effective frequency doubler scheme for SASE free electron lasers. It consists of an undulator tuned to the first harmonic, a dispersion section, and a tapered undulator tuned to the second harmonic. The first stage is a conventional soft X-ray SASE FEL. Its gain is controlled in such a way that the maximum energy modulation of the electron beam at the exit is about equal...
متن کاملShot Noise Startup of the 6 nm SASE FEL at the TESLA Test Facility
A strong effort to design a VUV Self Amplified Spontaneous Emission (SASE) Free Electron Laser (FEL) is currently taking place in DESY[1]. One of the merits of the SASE scheme is that it does not require any input signal from a master oscillator, since the spontaneous radiation emitted by a sufficiently intense electron beam entering in the undulator drives the high gain collective instability[...
متن کاملTesla Test Facility Stripline Readout System
The elaboration of the signals provided by the fourstripline Beam Position Monitors (BPM) on the superconducting linac TTF will be accomplished by parallel rf circuits, giving a signal of ~1 V /cm, indipendent of beam current, for both horizontal and vertical beam positions with time response ~1μs. and useful range > ±1 cm The performances with respect to thermal drifts and input dynamics are p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
سال: 1996
ISSN: 0168-9002
DOI: 10.1016/0168-9002(95)01470-5