Texture Evolution of Extruded AZ80 Mg Alloy under Various Compressive Forming Conditions
نویسندگان
چکیده
منابع مشابه
Improved Formability of Mg-AZ80 Alloy under a High Strain Rate in Expanding-Ring Experiments
Magnesium alloys offer a favored alternative to steels and aluminum alloys due to their low density and relatively high specific strength. Their application potentials are, however, impeded by poor formability at room temperature. In the current work, improved formability for the commercial magnesium AZ80 alloy was attained through the application of the high-rate electro-magnetic forming (EMF)...
متن کاملInvestigation of Ca in the Microstructural Evolution and Porosity Analysis of ZK60 Alloy in As-Cast and Extruded Conditions
This research work has been carried out to study the effect of different Ca contents (0.5, 1.0, 1.5, 2.0 and 3.0) on the microstructure and porosity content of ZK60 alloys. The samples were examined by using optical and scanning electron microscopy (SEM) to evaluate the modification efficiency of the alloy with different Ca concentrations. The cast specimens were modified, homogenized and extru...
متن کاملKinetics of SIMA AZ80 Magnesium Alloy
Semi-solid feedstock of AZ80 magnesium alloy modified by [trace] rare-earth Y element 10 (0, 0.2, 0.4, 0.8 wt.%) were fabricated by [strain-induced melting activation] (SIMA) in the form of 11 extrusion and partial remelting. The effect of Y addition on the microstructure evolution of [the] 12 extruded and [isothermally heat] treated alloy was observed by [using an] optical microscope (OM), 13 ...
متن کاملMicrostructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
The hot deformation behavior and microstructural evolution of an Al-Zn-Mg-Cu (7150) alloy was studied during hot compression at various temperatures (300 to 450 °C) and strain rates (0.001 to 10 s-1). A decline ratio map of flow stresses was proposed and divided into five deformation domains, in which the flow stress behavior was correlated with different microstructures and dynamic softening m...
متن کاملDetermination of Flow Stress and Coefficient of Friction for Extruded Anisotropic Materials under Cold Forming Conditions
The work material in metal working operations always shows some kind of anisotropy. In order to simplify the theoretical analysis, especially considering bulk deformation processes, anisotropy is usually neglected and the material is assumed to be isotropic. On the other hand, the analysis that considered the influence of anisotropy seldom incorporates the influence of friction. For predicting ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of Materials Processing
سال: 2012
ISSN: 1225-696X
DOI: 10.5228/kstp.2012.21.4.240