Texture and Deformation Behaviour through Thickness Direction in Strip-cast 4.5wt% Si Steel Sheet.
نویسندگان
چکیده
منابع مشابه
Analysis of deformation-induced surface morphologies in steel sheet
The surfaces of strained mild steel sheet specimens were examined with scanning laser confocal microscopy. Rigorous assessments were employed to establish the form of the roughness data. The small deviations from the ideal conditions observed in these assessments indicated that the stochastic process responsible for surface roughening does not conform to stationary, Gaussian, Markov statistics....
متن کاملInfluence of Antimony on the Texture and Properties of 2 % Si , 0 . 3 % A 1 Steel for Non - Oriented Sheet
The effect of additions of antimony (0.05% Sb) to silicon steel on the improvement of the electrical properties of non-oriented steel sheet was investigated. Measurements of surface segregation of Sb were performed under UHV conditions in the temperature range from 450 to 900 OC, using AES and TDS. Maximum equilibrium surface segregation of antimony was determined at 700 OC. At higher temperatu...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملSite-specific atomic-scale characterisation of retained austenite in a strip cast TRIP steel
Knowledge of carbon content in retained austenite (RA) with different neighbouring phases is essential to understand the chemical stability of RA, which is useful for microstructure tuning of transformation-induced plasticity (TRIP) steels. The present study investigates different morphologies and chemical compositions of RA by correlating electron backscattering diffraction, transmission elect...
متن کاملEvolution of Texture and Dislocation Distributions in High-ductile Austenitic Steel during Deformation
Fe-Mn-C austenitic steels exhibit outstanding high-ductile deformation in their plastic regions along with significant microstructural evolution. In this study, to characterize the microstructural evolution during deformation of these steels, line-profile and texture analyses were carried out using X-ray diffraction. The convolutional multiple whole profile fitting procedure was used for a line...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2000
ISSN: 0915-1559
DOI: 10.2355/isijinternational.40.1210