Tests on Inert-Gas Metal Welding of Corrosion Resisting Aluminum Alloy "ANP" Plates (Report 2)
نویسندگان
چکیده
منابع مشابه
Effect of Repeated Repair Metal Inert Gas Welding on Microstructural Properties, Corrosion Resistance, and Wear Behavior of 5083-H116 Aluminum Alloy
The effect of repeated repair welding, shielded with argon, on microstructural properties, corrosion resistance, and dry sliding wear behavior of aluminum alloy 5083/H116 were investigated. Samples were welded by metal inert gas welding method. 100% argon was used to protect fusion zone. Aluminum alloy 5356 was used as the filler metal. The samples for microstructure, corrosion, and wear tests ...
متن کاملIntegrated Risk Estimation of Metal Inert Gas (mig) and Metal Active Gas (mag) Welding Processes
Taking into account the technical characteristics of the welding processes, associated with the fulfi lling clients’ requirements, the assurance of safe and healthy working places as well as the environment protection the fundamental meaning belongs to the application of the appropriate methods of risk assessment of these processes. The paper presents the results of risk analysis, using an inte...
متن کاملPulsed Nd:YAG Laser Dissimilar Welding of Grade 2 Titanium Alloy to 3105-O Aluminum Alloy using AlSi5 Filler Metal
A special form of laser spot welding is introduced to overlap dissimilar welding of titanium (G2) to 3105-O aluminum alloy. A welding tactile seam tracking design using following pulses that result to a circular seam leads to spot like shape laser welding. This technique was conducted to joint overlapped grad 2 Titanium alloy (Ti G2) to 3105-O Al alloy, with 1, and 0.5 mm thicknesses respective...
متن کاملOptimization of Weld Bead Width in Tungsten Inert Gas Welding of Austenitic Stainless Steel Alloy
This paper investigates the effects of process parameters on weld bead width of austenitic stainless steel SS-310 in tungsten inert gas welding. The four parameters namely welding current, type of gas, gas flow rate and included angle of weld plates during butt joint were varied at three levels. The DOE approach was used to design experimental conditions. Orthogonal array L9 was used for carryi...
متن کاملHot cracking in tungsten inert gas welding of magnesium alloy AZ91D
Plates of 3–5 mm in thickness were extracted from an AZ91D ingot and then butt joints of the plates were produced using tungsten inert gas (TIG) welding method. The TIG arc was also used to deposit welding beads on some of the thin plates. No cracking was found in the butt joints. However, hot cracking was always observed to propagate from the heat affected zone (HAZ) under the welding bead int...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1956
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.25.612