Tests on Hydraulic Props Equipped with Yield Valves at Dynamic Load Modelling a Rock Burst

نویسندگان

چکیده

The article presents the results of tests on SHC-40 hydraulic props equipped with two types valve blocks: standard (with spring steel cylinder) and BZG-2FS gas spring). research was conducted using impact mass 4,000 kg extreme dynamic load free fall 20,000 released from different heights h. involved a camera speed image capture up to 1,200 frames/sec, which made it possible register stream liquid at determine opening time. study NHR10 fast acting relief, showed that prop block is more suitable effective in case areas high risk mining tremors rapid stress relief seam. Research methodology developed Central Mining Institute combines digital recording technique pressure registration images, allows acquire accurate analysis phenomena during testing.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Plunging Airfoil Load Characteristics Equipped with Gurney Flap

Numerous experiments have been conducted on plunging Eppler 361 airfoil in a subsonic wind tunnel. The experimental tests involved measuring the surface pressure distribution over the airfoil at Re=1.5×105. The airfoil was equipped with Gurney flap(heights of 2.6, 3.3 and 5% chord) and plunged at 6cm amplitude. The unsteady aerodynamic loads were calculated from the surface pressure measurement...

متن کامل

Experimental Study on Hydraulic Parameters of Vertical Drops Equipped to Horizontal Screen with Different Relative Distances

The present study aimed to investigate and compare the laboratory results of energy dissipation and length of vertical Drops equipped with horizontal Screens with the results of standard stilling basins of type one, two, three and four simple vertical Drops. For this purpose, 64 different experiments were performed on vertical Drops equipped with a horizontal Screen at relative distances of 0, ...

متن کامل

Comparison of Hydraulic-Burst and Ball-on-Ring Tests for Measuring Biaxial Strength

The statistics of failure of the hydraulic-burst (HB) test were compared with those of the ball-on-ring (BOR) test. Polycrystalline Al2O3 tape-cast specimens, both square and circular, in two different sizes, were tested. Both the mean strengths and the Weibull moduli from the BOR tests were approximately twice the values from the HB tests. The area (volume) under stress is much larger for the ...

متن کامل

Mathematical Modelling of Heavy-ore Load Train Equipped with Electronically Control Pneumatic Brake

The purpose of this paper is to derive suitable models for the design of controller for the heavy-ore load train system that is equipped with the newest railway brake system—the electronically control pneumatic brake (ECPB). Special train models are then obtained by simplifying the general one under different track conditions such as straight-flat, curving-flat and straight-slope, etc. A distin...

متن کامل

A Generalized Radial Flow Model for Hydraulic Tests in Fractured Rock

Models commonly used for the analysis of hydraulic test data are generalized by regarding the dimension of the flow to be a parameter which is not necessarily integral and which must be determined empirically. Mathematical solutions for this generalized radial flow model are derived for the standard test conditions: constant rate, constant head, and slug tests. Solutions for the less common, si...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Archives of Mining Sciences

سال: 2023

ISSN: ['0860-7001', '1689-0469']

DOI: https://doi.org/10.24425/122460