Testing steady-state analysis of single-ring and square pressure infiltrometer data

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Steady State Analysis of Nanofuel Droplet ‎Evaporation

The potential for nanofuels as one of the clean sources of energy on account of its enhanced combustion performance coupled with low emissions has been established. Considering the importance of the fuel evaporation phase in the entire combustion process, this work presents an attempt at applying the steady state analysis equations to nanofuel experimental data obtained from the li...

متن کامل

Analysis of Single Square Ring Reflectarray Element for Bandwidth Enhancement

An analysis of phase variation and phase range of single square ring element for broadband reflectarray antenna is presented in this paper. The analysis and design of reflectarray antenna element is presented based on variable size of the square ring element parameter a t X-band and Ka-band. The design procedure and critical parameters are also discussed. Modifying the current distribution of s...

متن کامل

consequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir

there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...

estimation of soil hydraulic parameters using double-ring infiltrometer data via inverse method

in this study, hydrus2d/3d software was used to estimate the hydraulic parameters of van genuchten-mualem model via inverse modeling using double-ring infiltrometers data in 3 different soil textures. nine scenarios of inverse modeling (divided in three groups) were considered with different number (5, 4 and 3) of fitted hydraulic parameters for optimization. in the first group, simulation was ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Geoderma

سال: 2016

ISSN: 0016-7061

DOI: 10.1016/j.geoderma.2015.07.002