Testing and numerical analysis of stainless steel I-sections under concentrated end-one-flange loading
نویسندگان
چکیده
منابع مشابه
Non-linear Dynamic Analysis of Steel Hollow I-core Sandwich Panel under Air Blast Loading
In this paper, the non-linear dynamic response of novel steel sandwich panel with hollow I-core subjected to blast loading was studied. Special emphasis is placed on the evaluation of midpoint displacements and energy dissipation of the models. Several parameters such as boundary conditions, strain rate, mesh dependency and asymmetrical loading are considered in this study. The material and geo...
متن کاملTesting and numerical modelling of Steel-Concrete-Steel with stud bolts connectors subject to push-out loading
Steel-concrete-steel (SCS) sandwich panels are composed of two steel plates with low thicknesses and high densities and strengths and one thick layer between both plates with low strength and density known as core that is composed of concrete. Cohesive material-epoxy resin or shear connectors are usually used to connect the plates to the concrete core. SCS sandwich composites are being develope...
متن کاملNumerical/Experimental Analysis of the Deformation of Tubes under Concentrated Load
Distortion and deformation of tubes during machining operations are very important. In this study, a tube used in magnetic drum separator under concentrated load (machining load) is considered. Using finite element simulation, deformities and their dependence on parameters such as the thickness of the tube and the place of concentrated force are observed and predicted. To compare and confirm th...
متن کاملMartensitic Transformation in Ultrafine-Grained Stainless Steel AISI 304L Under Monotonic and Cyclic Loading
The monotonic and cyclic deformation behavior of ultrafine-grained metastable austenitic steel AISI 304L, produced by severe plastic deformation, was investigated. Under monotonic loading, the martensitic phase transformation in the ultrafine-grained state is strongly favored. Under cyclic loading, the martensitic transformation behavior is similar to the coarse-grained condition, but the cycli...
متن کاملRatcheting of 316L stainless steel thin wire under tension-torsion loading
A series of cyclic tension-torsion tests under symmetric shear strain and asymmetric axial stress control in various loading paths are conducted on 100 μm-diameter 316L steel wires applying a micro tensiontorsion fatigue testing apparatus. The ratcheting strain of the thin wire increases with increasing axial mean stress and decreases in a sequence of linear, rhombic and circular paths. The mac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Constructional Steel Research
سال: 2019
ISSN: 0143-974X
DOI: 10.1016/j.jcsr.2019.02.020