TENSILE STRENGTH ANALYSIS OF SEA PANDAN LEAVES (PANDANUS TECTORIUS) FIBER REINFORCED EPOXY COMPOSITE
نویسندگان
چکیده
The use of sea pandan leaves (pandanus tectorius) as a composite material is intended to reduce the synthetic fibers and increase which are still wasted. This study aims determine tensile strength fiber based on manufacturing method direction used. Composite manufacture using Hand Lay Up Vacuum Bag methods. used 00 900. Tensile test ASTM D3039. results showed that composites made had higher than method, was 16.54 MPa for 13.60 900 direction. direction, 6.48 method.
منابع مشابه
Investigation of influence of tab types on tensile strength of E-glass/epoxy fiber reinforced composite materials
Mechanical response of E-glass/epoxy fiber reinforced composite was investigated in tensile loading. Different types of tabs were considered in order to evaluate their effects on the tensile strength of material. Specifically, two types of molded tabs and five types of bonded tabs were considered in the study. The influence of different amount of gripping pressures on failure mode and on tensil...
متن کاملSolid particle erosion of Bagasse fiber reinforced epoxy composite
Experiments were carried out to study the effects of impingement angle and particle velocity on the solid particle erosion behavior of Bagasse Fiber Reinforced Polymer Composites (BFRPCs). The erosive wear is evaluated at different impingement angles from 30° to 90° at four different velocities of 48, 70, 82 and 109 m/s. The erodent used is silica sand with the size range 150 – 250 m of irregul...
متن کاملNatural Composite Reinforced by Lontar (Borassus flabellifer) Fiber: An Experimental Study on Open-Hole Tensile Strength
A research has been conducted in the present study to investigate the effect of hole configuration on tensile strength of lontar fiber-reinforced composites. The lontar fiber-reinforced composites used in this study were produced by hand lay-up process. The lontar fiber-reinforced composites consist of short random fiber of 5 cm that contains 32% of nominal fiber volume as the reinforcement and...
متن کاملInfluence of Circular and Square Cut-outs on Fiber Glass/Epoxy Composite Laminate under Tensile Loading
Use of composites for a range of structural application in aircrafts, space-crafts, automobiles, etc., has widely spread in the last few years. Other than weight reduction, cut-outs provide pathways to link different aircraft parts. In this paper, an experimental investigation was conducted to study the effect of a cut-out on the tensile strength of the fiber glass/ epoxy composite plate. Geome...
متن کاملRELATIONSHIP OF TENSILE STRENGTH OF STEEL FIBER REINFORCED CONCRETE BASED ON GENETIC PROGRAMMING
Estimating mechanical properties of concrete before designing reinforced concrete structures is among the design requirements. Steel fibers have a considerable effect on the mechanical properties of reinforced concrete, particularly its tensile strength. So far, numerous studies have been done to estimate the relationship between tensile strength of steel fiber reinforced concrete (SFRC) and ot...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Vortex
سال: 2022
ISSN: ['2721-6152']
DOI: https://doi.org/10.28989/vortex.v3i2.1242