Tensile properties of copper, nickel, and 70-percent-copper-30-percent-nickel and 30-percent-copper-70-percent-nickel alloys at high temperatures
نویسندگان
چکیده
منابع مشابه
Bending properties of a new nickel-titanium alloy with a lower percent by weight of nickel.
INTRODUCTION The aim of the present study was to evaluate the bending properties of Hyflex instruments, which exhibit a lower percent in weight of nickel (52 Ni %wt) and compare them with other commercially available nickel-titanium (NiTi) rotary instruments. METHODS Ten instruments with tip size 25, 0.06 taper of each of the following NiTi rotary instrumentation techniques were selected for ...
متن کاملAbout 70 Percent of Older Adults Use Alternative Medicine
While previous research has been limited, this appears to be a higher rate than occurs within the general population, said Gong-Soog Hong, co-author of the study and professor of consumer sciences at Ohio State University. This study found that 71 percent of older adults used some form of alternative medicine in 2000. A study done in 2002, found a lower rate-about 62 percent – among all adults....
متن کاملMechanical Properties of Copper-Nickel-Titanium Archwires
MECHANICAL PROPERTIES OF COPPER-NICKEL-TITANIUM ORTHODONTIC WIRES Margaret Rosen, D.M.D. Marquette University, 2016 Introduction: The initial phase of orthodontic therapy relies on flexible wires, usually composed of a nickel-titanium alloy, to apply a substantially constant load during tooth movement. Copper has been added to nickel-titanium archwires, resulting in an alloy with potential clin...
متن کاملSynthesis and characterization of Nickel Copper Ferrite
Nano size nickel copper ferrite powders (NiCuFe2O4) have been prepared by a prepared by Co precipitation method. The resulting powders were characterized by X-ray diffraction (XRD), Scanning electron microscope (SEM).The result showed nanosize nickel copper ferrite(35.65nm). The powders showed extensive XRD line broadening and sizes of crystals observed from the XRD line broadening was35.65 nm,...
متن کاملCopper and Nickel Alloys Clad with Platinum and Its Alloys JOINING TECHNIQUES AND MECHANICAL PROPERTIES
Technical and economic considerations have identified an opportunity for composite materials which combine certain advantageous features of both noble and base metals. During an investigation of some platinum cladding techniques and of the properties of the resulting bimetals, data have been amassed which could have relevance to industrial a s well as to decorative applications. Here the effect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Research of the National Bureau of Standards
سال: 1957
ISSN: 0091-0635
DOI: 10.6028/jres.058.027