Tensile Properties of Aluminium Alloy Casting Melted using a Cold-Crucible Furnace
نویسندگان
چکیده
منابع مشابه
Fatigue and Anisotropic behaviours of cold rolled AA1200 Aluminium Alloy
This study examines the fatigue and anisotropy behaviour of cold rolled AA1200 aluminium alloy for light weight automotive connecting rod application. Aluminium (Al) 1200 ingots were melted at temperature of 680 0C (after one hour of heating) cast in sand mould and cast samples homogenized for 6 hrs at 480 0C. The cold rolling process was carried out after homogenisation for 10, 20, 30, 40 and ...
متن کاملTENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملEffect of quartz-silicon dioxide particulate on tensile properties of aluminium alloy cast composites
This paper describes an experimental investigation of the tensile properties of quartz-silicon dioxide particulate reinforced LM6 aluminium alloy composite. In this experimental, quartzsilicon dioxide particulate reinforced LM6 composite were fabricated by carbon dioxide sand moulding process with variation of the particulate content on percentage of weight. Tensile tests were conducted to dete...
متن کاملProtection Mechanisms for Blast Furnace Crucible Using Titanium Oxides
In modern steelmaking the duration of a working campaign for a blast furnace is related to the life of the crucible. Adding titanium oxide has been a frequent practice in the operation routines for modern blast furnaces, seeking the protection of the crucible walls, independently from its physical or chemical characteristics. These practices, as conventional operation of iron and steelmaking in...
متن کاملEffects of Solidification Time on Mechanical Properties and Wear Behaviour of Sand Cast Aluminium Alloy
An investigation was carried out to understand the effects of solidification time of the cylindrical specimen on hardness, wear rate and the coefficient of friction of Aluminium alloy (LM4). The commercially available LM4 Aluminium alloy was melted in a crucible furnace under argon atmosphere. The molten metal was poured into sand moulds having dissimilar size holes. The cast rods were tested f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 2003
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.67.9_452